are trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as
trademarks or service marks are the property of their respective holders as described at
www.altera.com/common/legal.html.
Altera warrants performance of its
semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any products and
services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use of any information, product, or service
described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device specifications before relying
on any published information and before placing orders for products or services.
ISO
9001:2008
Registered
Stratix IV Device Handbook
Volume 1
September 2012
Feedback Subscribe
1–2
Chapter 1: Overview for the Stratix IV Device Family
Feature Summary
Feature Summary
The following list summarizes the Stratix IV device family features:
■
Up to 48 full-duplex CDR-based transceivers in Stratix IV GX and GT devices
supporting data rates up to 8.5 Gbps and 11.3 Gbps, respectively
Dedicated circuitry to support physical layer functionality for popular serial
protocols, such as PCI Express (PCIe) (PIPE) Gen1 and Gen2, Gbps Ethernet (GbE),
Serial RapidIO, SONET/SDH, XAUI/HiGig, (OIF) CEI-6G, SD/HD/3G-SDI, Fibre
Channel, SFI-5, and Interlaken
Complete PCIe protocol solution with embedded PCIe hard IP blocks that
implement PHY-MAC layer, Data Link layer, and Transaction layer functionality
f
For more information, refer to the
IP Compiler for PCI Express User Guide.
■
■
■
Programmable transmitter pre-emphasis and receiver equalization circuitry to
compensate for frequency-dependent losses in the physical medium
Typical physical medium attachment (PMA) power consumption of 100 mW at
3.125 Gbps and 135 mW at 6.375 Gbps per channel
72,600 to 813,050 equivalent LEs per device
7,370 to 33,294 Kb of enhanced TriMatrix memory consisting of three RAM block
sizes to implement true dual-port memory and FIFO buffers
High-speed digital signal processing (DSP) blocks configurable as 9 x 9-bit,
12 x 12-bit, 18 x 18-bit, and 36 x 36-bit full-precision multipliers at up to 600 MHz
Up to 16 global clocks (GCLK), 88 regional clocks (RCLK), and 132 periphery
clocks (PCLK) per device
Programmable power technology that minimizes power while maximizing device
performance
Up to 1,120 user I/O pins arranged in 24 modular I/O banks that support a wide
range of single-ended and differential I/O standards
Support for high-speed external memory interfaces including DDR, DDR2,
DDR3 SDRAM, RLDRAM II, QDR II, and QDR II+ SRAM on up to 24 modular
I/O banks
High-speed LVDS I/O support with serializer/deserializer (SERDES), dynamic
phase alignment (DPA), and soft-CDR circuitry at data rates up to 1.6 Gbps
Support for source-synchronous bus standards, including SGMII, GbE, SPI-4
Phase 2 (POS-PHY Level 4), SFI-4.1, XSBI, UTOPIA IV, NPSI, and CSIX-L1
Pinouts for Stratix IV E devices designed to allow migration of designs from
Stratix III to Stratix IV E with minimal PCB impact
■
■
■
■
■
■
■
■
■
■
■
Stratix IV Device Handbook
Volume 1
September 2012 Altera Corporation
Chapter 1: Overview for the Stratix IV Device Family
Feature Summary
1–3
Stratix IV GX Devices
Stratix IV GX devices provide up to 48 full-duplex CDR-based transceiver channels
per device:
■
Thirty-two out of the 48 transceiver channels have dedicated physical coding
sublayer (PCS) and physical medium attachment (PMA) circuitry and support
data rates between 600 Mbps and 8.5 Gbps
The remaining 16 transceiver channels have dedicated PMA-only circuitry and
support data rates between 600 Mbps and 6.5 Gbps
■
1
The actual number of transceiver channels per device varies with device selection. For
more information about the exact transceiver count in each device, refer to
Table 1–1
on page 1–11.
For more information about transceiver architecture, refer to the
Transceiver
Architecture in Stratix IV Devices
chapter.
Figure 1–1
shows a high-level Stratix IV GX chip view.
Figure 1–1. Stratix IV GX Chip View
(1)
General Purpose
I/O and Memory
Interface
Transceiver Transceiver Transceiver Transceiver
Block
Block
Block
Block
PLL
General Purpose
I/O and
High-Speed
LVDS I/O with
DPA and Soft CDR
PCI Express
Hard IP Block
General Purpose
I/O and Memory
Interface
PLL
General Purpose
I/O and
High-Speed
LVDS I/O with
DPA and Soft CDR
PCI Express
Hard IP Block
PCI Express
Hard IP Block
Transceiver Transceiver Transceiver Transceiver
Block
Block
Block
Block
1
PLL
PLL
FPGA Fabric
(Logic Elements, DSP,
Embedded Memory,
Clock Networks)
PLL
PLL
General Purpose
I/O and
High-Speed
LVDS I/O with
DPA and Soft CDR
PCI Express
Hard IP Block
PLL
PLL
General Purpose
I/O and
High-Speed
LVDS I/O with
DPA and Soft CDR
PLL
General Purpose
I/O and Memory
Interface
PLL
General Purpose
I/O and Memory
Interface
PLL
PLL
Transceiver Block
General Purpose I/O and
High-Speed LVDS I/O
with DPA and Soft CDR
600 Mbps-8.5 Gbps CDR-based Transceiver
General Purpose I/O and 150 Mbps-1.6 Gbps
LVDS interface with DPA and Soft-CDR
Note to
Figure 1–1:
(1) Resource counts vary with device selection, package selection, or both.
September 2012
Altera Corporation
Stratix IV Device Handbook
Volume 1
1–4
Chapter 1: Overview for the Stratix IV Device Family
Feature Summary
Stratix IV E Device
Stratix IV E devices provide an excellent solution for applications that do not require
high-speed CDR-based transceivers, but are logic, user I/O, or memory intensive.
Figure 1–2
shows a high-level Stratix IV E chip view.
Figure 1–2. Stratix IV E Chip View
(1)
General Purpose
I/O and Memory PLL
Interface
PLL
General
Purpose
I/O and
High-Speed
LVDS I/O
with DPA
and Soft-CDR
PLL
General Purpose
I/O and Memory
Interface
PLL
General
Purpose
I/O and
High-Speed
LVDS I/O
with DPA
and Soft-CDR
FPGA Fabric
(Logic Elements, DSP,
Embedded Memory,
Clock Networks)
PLL
PLL
General
Purpose
I/O and
High-Speed
LVDS I/O
with DPA
and Soft-CDR
PLL
PLL
General
Purpose
I/O and
High-Speed
LVDS I/O
with DPA
and Soft-CDR
PLL
General Purpose
I/O and Memory PLL
Interface
General Purpose
I/O and Memory
Interface
PLL
PLL
General Purpose I/O and
High-Speed LVDS I/O with DPA
and Soft-CDR
General Purpose I/O and
150 Mbps-1.6 Gbps
LVDS interface with DPA and Soft-CDR
Note to
Figure 1–2:
(1) Resource counts vary with device selection, package selection, or both.
Stratix IV Device Handbook
Volume 1
September 2012 Altera Corporation
Chapter 1: Overview for the Stratix IV Device Family
Feature Summary
1–5
Stratix IV GT Devices
Stratix IV GT devices provide up to 48 CDR-based transceiver channels per device:
■
Thirty-two out of the 48 transceiver channels have dedicated PCS and PMA
circuitry and support data rates between 600 Mbps and 11.3 Gbps
The remaining 16 transceiver channels have dedicated PMA-only circuitry and
support data rates between 600 Mbps and 6.5 Gbps
■
1
The actual number of transceiver channels per device varies with device selection. For
more information about the exact transceiver count in each device, refer to
Table 1–7
on page 1–16.
For more information about Stratix IV GT devices and transceiver architecture, refer
to the
Transceiver Architecture in Stratix IV Devices
chapter.
Figure 1–3
shows a high-level Stratix IV GT chip view.
Figure 1–3. Stratix IV GT Chip View
(1)
1
General Purpose
I/O and Memory
Interface
Transceiver Transceiver
Block
Block
PLL
PLL
General Purpose
I/O and Memory
Interface
PLL
General Purpose
I/O and
High-Speed
LVDS I/O
with
DPA and Soft CDR
PCI Express
Hard IP Block
PCI Express
Hard IP Block
Transceiver Transceiver
Block
Block
Transceiver Transceiver
Block
Block
PLL
General Purpose
I/O and
High-Speed
LVDS I/O
with
DPA and Soft CDR
PCI Express
Hard IP Block
FPGA Fabric
(Logic Elements, DSP,
Embedded Memory,
Clock
Networks)
PLL
PLL
General Purpose
I/O and
High-Speed
LVDS I/O
with
DPA and Soft CDR
PCI Express
Hard IP Block
PLL
PLL
General Purpose
I/O and
High-Speed
LVDS I/O
with
DPA and Soft CDR
Transceiver Transceiver
Block
Block
PLL
General Purpose
I/O and Memory
Interface
PLL
General Purpose
I/O and Memory
Interface
PLL
PLL
Transceiver Block
General Purpose I/O and
High-Speed LVDS I/O
with
DPA and Soft CDR
600 Mbps-11.3 Gbps CDR-based Transceiver
General Purpose I/O and
up
to 1.6 Gbps
LVDS interface
with
DPA and Soft-CDR
Note to
Figure 1–3:
(1) Resource counts vary with device selection, package selection, or both.
By observing the circuit schematics of some microcontrollers, I found that some microcontrollers have designed the EEPROM part of the circuit, while some microcontrollers have not designed this part o...
Translated from: https://opensource.org/node/1218Stop saying "open source". The U.S. Court of Appeals for the Ninth Circuit recently affirmed a lower court ruling, concluding what we have known all al...
Adopt CC2652, use LAUNCHXL-CC26X2R1 development board. Serial port connected to Raspberry Pi.
The network coordinator of CC2652 is based on the optimized simple link TI-RTOS.1. Optimize the wireless t...
It's like this. I bought an LM35CZ temperature sensor online a few days ago, and then used simulation to make a circuit with no problems. When I used the dual power supply mode given in the sensor man...
The MSP-EXP430FR2311 LaunchPad Development Kit is an easy-to-use microcontroller development board for the MSP430FR2311 MCU.It contains all the resources needed to quickly start development on the MSP...
[i=s]This post was last edited by MianQi on 2021-2-27 13:15[/i]The following tests may be all on the Ubuntu 20.04 system platform. STM32CubeIDE runs very well here. If it is connected to the Internet,...
Foreign media Hardwaretimes reported that Intel, the leader in processors, is actively deploying IDM2.0. In addition to the construction of advanced process wafer fabs in the United States, Intel has...[Details]
1 Introduction
At present, sulfur dioxide emissions from coal combustion in China account for more than 90% of the total sulfur dioxide emissions, of which the emissions of pollutants from ther...[Details]
Recently, high-end material testing company Sembcorp Nanotech received tens of millions of yuan in Series B financing, led by ECC Capital and Nachuan Capital. The company's founder and CEO, Li Xiao...[Details]
November 4, 2022, Shanghai, China - The second SAIC Zero-beam SOA Platform Developer Conference officially opened.
The first "Feifan R7" equipped with OPPO Carlink was unveiled at the conferenc...[Details]
Silicon Carbide MOSFET
Product Description:
Feizeng Semiconductor's automotive-grade silicon carbide products have been launched in a variety of mainstream market specif...[Details]
It goes without saying that KNX ® is considered a leading protocol for building and home automation, with more than 8,000 products certified by the KNX Association, 500 member companies and nearly 10...[Details]
Small power electric motors need to be 3C certified before they can be sold normally in the country.
Motor 3c certification rules:
The 3C certification of electric motors requires t...[Details]
The optocoupler introduced in this article is a device composed of a light-emitting diode and a photosensitive transistor. The light-emitting diode converts the electrical signal on the input side ...[Details]
Switching DC/DC converters can be divided into the following three categories according to their structure:
① Inductive DC/DC converter, as shown in Figure (a);
② Unadjustable capacitor c...[Details]
Tektronix has launched the TBS2000B series oscilloscope. Whether you are facing an industrial design and debugging environment or a university teaching laboratory, with the new features provided by t...[Details]
Panos Panay, the creator of Surface, said on Twitter that the launch date of Microsoft's new true wireless headset Surface Earbuds will be postponed to spring 2020. Panos Panay said: "Product manuf...[Details]
A few days ago, Google launched the Pixel 4a mobile phone. Although it still uses 4G network, the price starts at US$349 (about RMB 2,431), which is much cheaper than the iPhone SE. In terms of har...[Details]
China Energy Storage Network:
Changes and re-signings of annual trading contracts in 2021
In October 2021, the National Development and Reform Commission issued the "Notice on...[Details]
Processor Technology Development
Point-of-load
(POL) processor power supply design
for core and I/O voltages is becoming increasingly challenging due to higher integration, faster...[Details]
Grenoble, France, November 5, 2024 -
Jolt Capital, a European growth-focused deep tech company, announced today that it has acquired the power management and signal processing IP business (the ...[Details]