Resistor values are typically 120 to 240 ohms for 3.3V operation and 82 to 120 ohms for 2.5V
operation.
Figure 7 - Pull Up Pull Down Termination
Resistor values are typically for 3.3V operation
For 2.5V operation, the resistor to ground is 62 ohms and the resistor to supply is 240 ohms
There are numerous application notes on terminating and interfacing PECL logic and the two most common methods are a single resistor to ground, Figure 6,
and a pull-up/pull-down scheme as shown in Figure 7. An AC coupling capacitor is optional, depending on the application and the input logic requirements of
the next stage.
One of the most important considerations is terminating the Output and Complementary Outputs equally. An unused output should not be left un-
terminated, and if one of the two outputs is left open it will result in excessive jitter on both. PC board layout must take this and 50 ohm impedance matching
into account. Load matching and power supply noise are the main contributors to jitter related problems.
LVDS Application Diagrams
+3.3V
OE or NC
10nF
1nF
1
6
Receiver
100
3
4
+3.3V
OE or NC
10nF
1nF
1
6
10nF
100
3
4
Receiver
OE or NC
2
5
OE or NC
2
5
10nF
Figure 8 - LVDS to LVDS, internal 100Ω
Some LVDS structures have an internal 100 ohm resistor on the
input and do not need additional components.
Figure 9 - LVDS to LVDS, External 100Ω and AC block ing caps
One of the most important considerations is terminating the Output and Complementary Outputs equally. An unused output should not be left un-
terminated, and if one of the two outputs is left open it will result in excessive jitter on both. PC board layout must take this and 50 ohm impedance matching
into account. Load matching and power supply noise are the main contributors to jitter related problems.
IoT communication technology is divided into wired and wireless, and different communication methods are used according to different application scenarios and needs.
Wired communicationWired communica...
[i=s]This post was last edited by bluefox0919 on 2019-1-2 17:30[/i] I have an old project on hand. The original designer has left the company for many years... I need to solve the ESD. The appearance ...
The strain gauge bridge has a zero output of 4mV, a full-scale output of about 4.5mV, and a full-scale output change of 0.5mV, but the zero offset is as high as 4mV;zero offset compensation solution:1...
The program requires that if p1.3 is pressed short, p1.0 will be inverted, and if p1.3 is pressed long, p1.6 will be inverted. The following is the program:
#include "msp430g2553.h"
#define IDLE 0
#de...
[i=s] This post was last posted by robinqjx on 2019-2-13 11:19 Edit[/i] [align=left][font=-webkit-standard][size=4][color=#000000][b]【NXP Rapid IoT Review】- NXP Rapid IOT APP Mobile Bluetooth Networki...
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
