(5 ±1 seconds and charge/discharge not exceeding 50 mA)
0.1%
1,000 megohm microfarads or 100 GΩ
(Rated voltage applied for 120 ±5 seconds @ 25°C)
Parameters/Characteristics
To obtain IR limit, divide MΩ-µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.
Capacitance and dissipation factor (DF) measured under the following conditions:
1 MHz ±100 kHz and 1.0 Vrms ±0.2 V if capacitance ≤ 1,000 pF
1 kHz ±50 Hz and 1.0 Vrms ±0.2 V if capacitance > 1,000 pF
Note: When measuring capacitance it is important to ensure the set voltage level is held constant. The HP4284 and Agilent E4980 have a feature known as
Automatic Level Control (ALC). The ALC feature should be switched to "ON."
Post Environmental Limits
High Temperature Life, Biased Humidity, Moisture Resistance
KEMET reserves the right to substitute product with an improved temperature characteristic, tighter capacitance tolerance and/or higher voltage capability within
the same form factor (configuration and dimensions).
These products are protected under US Patents 7,172,985 & 7,670,981, other patents pending, and any foreign counterparts.
KEMET reserves the right to substitute product with an improved temperature characteristic, tighter capacitance tolerance and/or higher voltage capability within
the same form factor (configuration and dimensions).
These products are protected under US Patents 7,172,985 & 7,670,981, other patents pending, and any foreign counterparts.
[i=s]This post was last edited by dcexpert on 2019-10-14 09:14[/i]In CircuitPython, I2C, SPI, UART and other functions are provided by the busio module, so you need to import busio before you can use ...
Dear teachers,I drew a four-layer board and laid copper, and the following two problems occurred. Can you give me a solution?
1 For the same GND network, some boxes have no copper, while others can in...
The 0-10V analog signal is converted into a modulated signal by the APC chip GP9301M, and then transmitted to the PAC chip GP8101M after passing through the isolation capacitor. The GP8101M demodulate...
IntroductionThe HPM6700/6400 series MCU is a high-performance real-time RISC-V microcontroller from Shanghai Xianji Semiconductor Technology Co., Ltd., which provides great computing power, efficient ...
RISC-V is an open source instruction set architecture (ISA) based on the Reduced Instruction Set (RISC). It is a completely open instruction set that can be freely used by academic institutions or com...
Today, Evolution Semiconductor, a compound semiconductor substrate company specializing in fourth-generation semiconductor gallium oxide, announced the completion of an angel round of financing of te...[Details]
The PCB schematic is as follows. I remember it was drawn with protel at that time. The circuit schematic is as follows: Drawing software is the same as above Experiment reference C language code ...[Details]
SSP (synchronous Seril Port) synchronous serial port controller, can support SPI, TI and Microwire protocols, one bus allows multiple slaves, but only one master and one slave are allowed to communic...[Details]
A hybrid system that can challenge the Prius head-on with its technological strength seems to be coming soon. In December 2010, Honda announced that it would begin verification experiments on elect...[Details]
For
battery
-powered portable devices, in addition to breaking through the limitations of processing power,
the performance of
portable system
power supplies
also needs to be contin...[Details]
In today's electrical control field, the inverter is definitely the most popular star product. Unfortunately, as an inverter that integrates electrical, electronic and other technologies, it is by ...[Details]
Insulation resistance tester is completed using special testing equipment. The most commonly used test instrument is , but other types of instruments can be used to check the integrity of different i...[Details]
There has been a voice echoing in the industry: "Has the terminal form factor such as mobile phones reached its end?" 5G has provided our economy with an unprecedented opportunity and also set off a ...[Details]
1 Overview
The single-chip wireless serial interface circuit is composed of the MICRF102 single-chip transmitter chip and the MICRF007 single-chip receiver chip, and operates in the 300~440 MH...[Details]
According to Yancheng News, the Derun Hualin Electronics Project has been fully put into production recently, and currently has orders worth more than 50 million yuan. It is expected that after furth...[Details]
When pure electric vehicles are driving on highways, the range will be significantly reduced. This is a common problem of pure electric vehicles at present. This is also related to the technical ch...[Details]
IoT devices, such as portable health monitors and wearables, are inherently vulnerable to hacking because they are connected to the internet. From attacking devices with a distributed denial of servi...[Details]
Recently, the performance comparison between Samsung's Exynos chips and Snapdragon chips has sparked a lot of discussion. Some angry users even submitted a petition online, suggesting that Sams...[Details]
Audi has spent a lot of time building up its electric drive system, which we have introduced before. Today, we will continue to share Audi’s choice of motors.
● The system output of the ...[Details]
IGBT has been widely used in power electronic devices represented by inverters and various power supplies.
IGBT
combines the advantages of bipolar power transistors and power MOSFETs, and has t...[Details]