METALLIZED POLYESTER
TAPE WRAP AND EPOXY FILL CASE
X663F
PAGE 5 OF 5
GENERAL SPECIFICATIONS
PHYSICAL CHARACTERISTICS
CONSTRUCTION:
NON-INDUCTIVE WOUND METALLIZED POLYESTER.
CASE:
FLAME RETARDANT TAPE WRAP CASE AND EPOXY FILL.
LEAD MATERIAL:
AXIAL SOLDER COATED OR TINNED SOLID WIRE, AWG AS SPECIFIED IN TABLES.
DIMENSIONS:
AS SPECIFIED IN TABLES.
ELECTRICAL CHARACTERISTICS
CAPACITANCE:
AS SPECIFIED IN TABLES ± REQUESTED TOLERANCE WHEN MEASURED AT OR
REFERRED TO 1000 ± 20 HZ AND 25 ± 5 °C.
TOLERANCE:
±5%, ±10%, AND ±20% AVAILABLE. OTHER TOLERANCES AVAILABLE UPON REQUEST.
DISSIPATION FACTOR:
SHALL NOT BE GREATER THAN 1.0% WHEN MEASURED AT OR REFERRED TO
1000 ± 20 HZ AND 25 ± 5 °C; EXCEPT FOR C APACITORS HAVING A THICKNES LESS THAN 0.202"
(5.1mm), THEN DF SHALL NOT BE GREATER THAN 1.5%.
INSULATION RESISTANCE:
SHALL BE GREATER THAN 25,000 MΩ FOR CAPACITANCE VALUES 0.40 µF
AND LESS OR 10,000 MΩ X µF FOR CAPACITANCE VALUES GREATER THAN 0.40 µF WHEN MEASURED
AFTER 2 MINUTES ELECTRIFICATION AT RATED VOLTAGE OR 500VDC, WHICHEVER IS LESS, AND
25 ± 5 °C.
DIELECTRIC STRENGTH:
200% RATED VOLTAGE FOR 1 MINUTE THROUGH A LIMITING RESISTANCE
OF 100 OHMS/VOLT AT 25 ± 5 °C.
RATED VOLTAGE:
50VDC, 100VDC, 200VDC, 400VDC, AND 600VDC AVAILABLE.
TEMPERATURE:
-55 °C TO +85 °C AT FULL RATED VOLTAGE OPERATIONAL TEMPERATURE, DERATE
LINEARLY 1.25%/°C ABOVE +85 °C TO +125 °C, +125 °C MAX STORAGE TEMPERATURE.
ADDITIONAL INFORMATION
ORDERING INFORMATION:
ALL ASC CAPACITORS ARE ORDERED BY "FAMILY CAP-TOL-VOLT"
DESIGNATION. (I.E. TO ORDER AN X663F 1.0µF, ±10%, 200VDC CAPACITOR, REQUEST PART NUMBER
"X663F 1-10-200")
SEE ALSO:
"GENERAL INFORMATION - POLYESTER CAPACITORS" DOCUMENT FOR ADDITIONAL
PHYSICAL, ELECTRICAL, AND PERFORMANCE CHARACTERISTICS NOT MENTIONED IN THIS FILE.
WARNING:
INFORMATION ON THIS FILE IS SUBJECT TO CHANGE WITHOUT NOTICE AT ASC'S
DISCRETION.
LAST MODIFIED: 09/26/01
301 WEST O STREET
•
OGALLALA, NE 69153
Phone: (308) 284-3611
Fax: (308) 284-8324
e-mail: sales@ascapacitor.com
web: www.ascapacitor.com