Above ratings are based on the thermal resistances using a multi-layer circuit board (EIA/JESD51). For mounting on a mono-layer board, power derating shall be
needed. Please inquire of us about conditions.
※1 素子毎の負荷電力の合計が、パッケージ定格電力を超えない条件で御½用ください。
※1 Total power consumption of all elements should not exceed the package power rating.
The resistor of this product is formed by narrow patterning a thin metal film. Thus, application of excessive voltage causes burn and destruction of the resistive film, abnormality
in resistance or open resistance and loss of proper function. The properly and electrostatically measured taping materials are used for the components, but attention should be paid
to the fact that there is some danger the parts may be destructed by static electricity(equivalent to 500V or over at 100pF, 1.5kΩ) to cause a change in resistance in the conditions
of an excessive dryness when mounting on the boards. Similarly, care should be given not to apply the excessive static electricity at the time of mounting on the boards. When
designing, consideration can be taken into withstanding ESD for customized KPC products. Please consult with us about the details.
●
Hand soldering by iron soldering or repairment are not recommended because KPC is a multi-pin product.
●
Avoid storing components under direct sun rays, high temperature/humidity. Direct sun rays will cause quality change of taping and difficulty of keeping appropriate peeling
strength. In the case of 5〜35℃/35〜75%RH, there is no deterioration of solderability for 12 months, but take special care for storing, because condensation, dust, and toxic gas
like hydrogen sulfide, sulfurous acid gas, hydrogen chloride, etc. may drop solderability.
The above circuit converts the PWM voltage into a DC voltage through RC filtering. The principle is that the capacitor will charge and discharge. When the PWM power supply is low, the capacitor will d...
When this circuit is measured, the voltage across R32 cannot be stabilized at 2.5V. The measured result is 1.9V. When the resistance value of the load R33 is changed, the voltage across R32 will also ...
I downloaded IAR and CC1310 SDK, and installed them all to disk D.Then I followed the steps on the Internet and loaded and opened a project in the IAR development environment. I double-clicked the sou...
[i=s]This post was last edited by yang_alex on 2019-7-13 23:52[/i]【CH549 Review】Part 2 Program Burning Tool ReviewNetizens who have used CH554 before need to pay attention. Since Qinheng has added a n...
In a computer system, the bus is a common channel for the CPU, memory, input and output devices to transmit information; the various components of the host are connected through the bus, and external ...
I'm used to playing while charging, but now I'm a little afraid to do that.
[Most current models support fast charging, so it is not a big problem to play while charging. The reason why we usually do ...
Overvoltage protection
There are many kinds of devices to choose from in the design, such as transient suppression diodes (
TVS
),
varistors
, semiconductor discharge tu...[Details]
For purchasers, most units and departments are configuring UPS for the first time and are still unfamiliar with the technology and its use and maintenance. Here are some opinions on how to evaluate...[Details]
In addition to understanding and memorizing basic formulas, electricians also need to be able to use relevant calculation tables, such as commonly used physical quantities and their units, commonl...[Details]
China Energy Storage Network News:
On September 27, the Ministry of Industry and Information Technology, the National Development and Reform Commission, the Ministry of Finance, and the Sta...[Details]
Principle of TinySwitch II Series Second Generation Micro Monolithic Switching Power Supply
The TinySwitch-II series is the second generation of enhanced isolated micro-monolithic swit...[Details]
Nanjing Hexin Automation Co., Ltd. (hereinafter referred to as "Nanjing Hexin") was established in 2017. Its headquarters is located in Nanjing Xingang National Economic Development Zone. It has es...[Details]
At present, the AC power supply combined with control methods mainly include the following:
1. Primary feedback power supply. This technology is used to drive low-power LED lamps and is trans...[Details]
#include
#include intrins.h
#define uchar unsigned char
#define uint unsigned int
#define cmd P0 //Define the data interface of LCM, please modify according to the actual situation
#defin...[Details]
Infrared electric ovens are popular among users for their fast heating speed, low power loss and high heating quality. However, because electric ovens consume a lot of electricity and have a relati...[Details]
Variety is generally good for the market, but it can also frustrate engineers and end users. Selecting a control platform is a long-term investment with associated expenses, such as training and supp...[Details]
Relying on mountains will cause them to fall; relying on people will cause them to run away; only by being self-reliant and strong can we achieve steady and positive development On the last day of ...[Details]
The global automobile market has begun to recover steadily, especially the rapid recovery of the Chinese automobile market, which has rapidly driven a substantial increase in chip demand. More import...[Details]
Digital blogger @数码闲聊站 recently revealed a lot of information about new phones with under-screen cameras and folding screens from various manufacturers. Although some of them did not explicitly state...[Details]
1 Introduction
Recently, solar energy
is being considered
for a wider range of consumer electronics applications, including mobile phone chargers. The power provided by solar panels...[Details]
Intelligent soft start cabinet is an electrical equipment widely used in the industrial field. It controls the starting current of the motor to achieve soft start and soft stop of the motor, thereb...[Details]
Switching Power Supply Study Group
京公网安备 11010802033920号
EEWORLD
