Features ....................................................................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
LVPECL and FlexSwing Termination .................................................................................................................................. 17
LVDS, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 18
HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V ...................................... 18
Low-power HCSL, Supply Voltage: 1.8 V
±5%,
2.5 V ±10%, 3.3 V ±10%, 2.25 V to 3.63 V, 1.71 V to 3.63 V.................... 18
Dimensions and Patterns ― 2.0 x 1.6 mm x mm ....................................................................................................................... 19
Dimensions and Patterns ― 2.5 x 2.0 mm x mm ....................................................................................................................... 20
Dimensions and Patterns ― 3.2 x 2.0 mm x mm ....................................................................................................................... 21
Revision History ......................................................................................................................................................................... 22
Rev 0.53
Page 3 of 23
www.sitime.com
SiT9375
Low Jitter Differential XO for Standard Networking Frequencies
Electrical Characteristics
ADVANCED
All Min and Max limits in the Electrical Characteristics tables are specified over operating temperature and rated operating
voltage with standard output termination shown in the termination diagrams. Typical values are at 25°C and nominal
supply voltage.
Table 3. Electrical Characteristics – Common to All Output Signaling Types
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
–
Min.
Typ.
Max.
Unit
MHz
ppm
Condition
Refer to frequencies listed in
Ordering Information
section.
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and 10 years
aging at 25°C
Inclusive of initial tolerance, operating temperature, rated power
supply voltage, load variation of 15 pF
±
10%, and first year aging
at 25°C
Ambient temperature of 25°C
Extended commercial, ambient temperature
Industrial, ambient temperature
Ambient temperature
Extended industrial, ambient temperature
Voltage-supply order code “YY”
Voltage-supply order code “XX”
Voltage-supply order code “18”.
Contact SiTime
for 1.5 V
Voltage-supply order code “25”
Voltage-supply order code “33”
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
Pins 1 and 2 for OE and SE, respectively
See
Figure 5
and
Figure 7
Measured from the time Vdd reaches its rated minimum value
Measured from the time OE pin toggles to enable logic level to
the time clock pins reach 90% of swing. See
Figure 12
Measured from the time OE pin toggles to disable logic level to
the last clock edge. See
Figure 13
12 kHz to 20 MHz offset frequency integration bandwidth,
156.25 MHz
12 kHz to 20 MHz offset frequency range, 156.25 MHz
12 kHz to 20 MHz offset frequency range, 155.52 MHz
156.25 MHz
156.25 MHz
Frequency Range
Standard frequencies
–
±20
Frequency Stability
–
–
–
10 Year Aging
Operating Temperature Range
F_10y
T_use
–
-20
-40
-40
-40
Supply Voltage
Vdd
1.71
2.25
1.71
2.25
2.97
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Startup Time
Output Enable Time
Output Disable Time
VIH
VIL
Z_in
DC
T_start
T_oe
T_od
70%
–
–
45
–
–
–
–
–
–
±1
–
–
–
–
–
–
1.80
2.50
3.30
–
–
100
–
1
–
–
±25
±30
±50
–
+70
+85
+95
+105
ppm
ppm
ppm
ppm
°C
°C
°C
°C
V
V
V
V
V
Temperature Range
Supply Voltage
3.63
3.63
1.89
2.75
3.63
Input Characteristics
–
Vdd
30%
–
55
5
100+3 clock
cycles
100+3 clock
cycles
Vdd
kΩ
%
ms
ns
ns
Output Characteristics
Startup, OE and SE Timing
Jitter and Phase Noise
RMS Phase Jitter (random)
Spurious Phase Noise
RMS Period
Jitter
[1]
Jitter
[1]
T_phj
PN_spur_a
PN_spur_b
T_jitt_per
T_jitt_cc
Peak Cycle-to-cycle
–
–
–
–
–
200
-110
-80
1
6
–
–
–
–
–
fs
dBc
dBc
ps
ps
Note:
1. Measured according to JESD65B.
Rev 0.53
Page 4 of 23
www.sitime.com
SiT9375
Low Jitter Differential XO for Standard Networking Frequencies
ADVANCED
Table 4. Electrical Characteristics – LVPECL
|
Supply voltages: 2.5 V
±10%,
3.3 V
±10%,
2.25 V to 3.63 V
Parameter
Current Consumption, Output
Enabled without Termination
Current Consumption, Output
Enabled with Termination 1
Current Consumption, Output
Enabled with Termination 2
Current Consumption, Output
Disabled without Termination
Current Consumption Output
Disabled with Termination 1
Current Consumption, Output
Disabled with Termination 2
OE Leakage Current
Symbol
Idd_oe_nt
Idd_oe_wt1
Idd_oe_wt2
Idd_od_nt
Idd_od_wt1
Idd_od_wt2
I_leak
Min.
–
–
–
–
–
–
–
Typ.
43
52
71
58
58
86
37
Max.
–
–
–
–
–
–
–
Unit
mA
mA
mA
mA
mA
mA
mA
Condition
Excluding load termination current
Including load termination current. See
Figure 15
for
termination
Including load termination current. See
Figure 18
for
termination
Excluding load termination current
Including load termination current. See
Figure 15
for
termination
Including load termination current. See
Figure 18
for
termination
OE = disable logic, DC termination, OUTP and OUTN held
Are you interested in the three boards mentioned in the title? ? ?If you are interested, please reply to my post and say "Let's play"!Let me introduce these three boards:LAUNCHXL-F280049CTexas Instrum...
Recently, there have been many rumors about the 2G network being phased out, and various news have been flying around, even becoming a hot search topic. How do we interpret the true meaning of this in...
First, I used floating point numbers to set the voltage (actually I should have used fixed point numbers), and then I should have used event sets for inter-thread communication (yes, I was lazy again)...
The strategy of ST chip is ambitious! It not only deepens the cooperation with universities, but also has a wide application in the domestic market! In the last year, the price of an ordinary STM32F10...
[i=s]This post was last edited by bigbat on 2019-2-22 11:52[/i] After lighting up the LED in the previous article, start testing Ethernet. [color=#0000ff]The board is provided by ST, [url=https://www....
This is the 24V input power processing part on a microcontroller circuit board.
What is TV_RM in the red circle? Is it a TVS tube? After being connected in parallel with the resistor, both ends are co...
ARM system clock initialization:
This requires knowing what is a clock pulse signal, what is a clock frequency, and what is a clock source.
Clock pulse signal:
Clock pulse ...[Details]
The wiring method of converting a three-phase inverter to a 220V single-phase is a highly technical job, which requires a deep understanding of the working principle and wiring method of the invert...[Details]
Mitsubishi PLC (Programmable Logic Controller) is a control device widely used in the field of industrial automation. It controls various mechanical equipment through programming and has the charac...[Details]
Since 2021, the penetration rate of China's hybrid market, especially plug-in hybrid vehicles (PHEVs), has increased significantly.
According to the report, the market penetration rate...[Details]
Knowing the main power switch location of ABB industrial robots is essential to ensure the safe operation and maintenance of the robots. In this article, we will introduce the main power switch loc...[Details]
On October 30, The Information's latest report pointed out that the standard version of the iPhone 17 has passed the early development stage. Apple's partner Foxconn is carrying out early manufactu...[Details]
On October 28, Intel announced today that it will expand the capacity of its packaging and testing base in Chengdu. This move aims to deepen its service commitment to the Chinese market and acceler...[Details]
From October 31 to November 1, the Global New Energy Vehicle Cooperation and Development (Shanghai) Forum (GNEV2024•Shanghai) hosted by the China Electric Vehicle 100 was officially held.
Wit...[Details]
In the first "International Solar Storage Direct Flexible Technology Application Competition" held in Xiongan New Area, Chengde Xinxin Vanadium Titanium Energy Storage Technology Co., Ltd. won ...[Details]
Industrial controllers are core devices in modern industrial automation systems. Their core technologies mainly include the following aspects:
Hardware Technology
The hardware t...[Details]
On the morning of October 26, Wei County held a groundbreaking ceremony for the Qingyun Fengda New Energy Storage Project. Cui Yaopeng, secretary of the county party committee, attended and delivered ...[Details]
Low-voltage electrical appliances play a vital role in the power system. They are responsible for controlling and protecting the normal operation of the circuit. Among the many low-voltage electric...[Details]
The inverter is a power electronic device widely used in the field of industrial automation. Its main function is to adjust the speed of the motor to meet the needs of different processes and equip...[Details]
According to foreign media reports, Ford Motor Company has applied for a new patent for its advanced interior lighting system, which may be used in future Ford vehicles. The patent was submitted on...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
