5.0 mm x 3.2 mm Package Pinout ............................................................................................................................................... 1
Ordering Information .................................................................................................................................................................... 2
Device Configurations and Pin-outs ............................................................................................................................................. 9
Pin-out Top Views................................................................................................................................................................. 9
Test Circuit Diagrams for LVCMOS and Clipped Sinewave Outputs ......................................................................................... 10
Frequency Stability ............................................................................................................................................................. 16
Output Frequency and Format............................................................................................................................................ 16
Output Frequency Tuning ................................................................................................................................................... 16
Control Voltage Bandwidth ................................................................................................................................................. 20
Pull Range and Average Pull Range .................................................................................................................................. 22
Output Frequency ............................................................................................................................................................... 23
I
2
C Control Registers .......................................................................................................................................................... 25
Serial Interface Configuration Description .......................................................................................................................... 28
Serial Signal Format ........................................................................................................................................................... 28
Parallel Signal Format ........................................................................................................................................................ 29
Parallel Data Format ........................................................................................................................................................... 29
I
2
C Timing Specification ...................................................................................................................................................... 31
I
2
C Device Address Modes ................................................................................................................................................. 32
Schematic Example ............................................................................................................................................................ 33
Dimensions and Patterns ........................................................................................................................................................... 34
Additional Information ................................................................................................................................................................ 36
Revision History ......................................................................................................................................................................... 37
Rev 1.06
Page 3 of 38
www.sitime.com
SiT5156
1 MHz to 60 MHz, ±0.5 to ±2.5 ppm, Elite Platform™ Super-TCXO
Electrical Characteristics
All Min and Max limits are specified over temperature and rated operating voltage with 15 pF output load unless otherwise
stated. Typical values are at 25°C and 3.3 V Vdd.
Table 1. Output Characteristics
Parameters
Nominal Output Frequency Range
Operating Temperature Range
Symbol
F_nom
T_use
Min.
1
-20
-40
-40
Frequency Stability over
Temperature
Initial Tolerance
Supply Voltage Sensitivity
F_stab
–
–
–
F_init
F_Vdd
–
–
–
–
Output Load Sensitivity
F_load
–
–
–
Frequency vs. Temperature Slope
ΔF/ΔT
–
–
–
Dynamic Frequency Change during
Temperature Ramp
One-Year Aging
20-Year Aging
F_dynamic
–
–
–
F_1y
F_20y
–
–
Typ.
–
–
–
–
–
–
–
–
±7.10
±11.83
±28.40
±0.81
±1.35
±3.24
±15
±25
±60
±0.13
±0.21
±0.50
±1
±2
Max.
60
+70
+85
+105
±0.5
±1.0
±2.5
±1
±16.25
±32.50
±65.0
±2.75
±5.50
±11.00
±25
±50
±100
±0.21
±0.42
±0.83
–
–
Unit
MHz
°C
°C
°C
ppm
ppm
ppm
ppm
ppb
ppb
ppb
ppb
ppb
ppb
ppb/°C
ppb/°C
ppb/°C
ppb/s
ppb/s
ppb/s
ppm
ppm
Initial frequency at 25°C at 48 hours after 2 reflows
This control board is mainly used for a cost-effective switching power supply control board. It uses high-performance MCU GD32 to sample voltage, current, and temperature data, and outputs PWM control...
The analog front end of high-speed end equipment such as phased array radar, wireless communication testers, and electronic warfare requires synchronized multi-transceiver signal chains. Each transcei...
I have now connected the CC2541 development board to the Bluetooth main module.The CC2541 development board sends data to the Bluetooth main module, and the Bluetooth main module can receive it.
Howev...
1. Who is the coprocessor?
Coprocessor: A chip that offloads specific processing tasks from a system's microprocessor. For example, a math coprocessor can handle number crunching; a graphics coproces...[Details]
ATmega8's eeprom read and write operations are tested to be OK The microcontroller source program is as follows: //ICC-AVR application builder // Target : M8 // Crystal: 8.0000Mhz #include iom8v....[Details]
introduction
As people's demand for large-screen color TVs continues to increase, plasma displays (PDPs) have a considerable advantage in the competition due to their unique advantages such ...[Details]
Recently, Shanghai Electric Guoxuan New Energy Technology Co., Ltd. (hereinafter referred to as "Electric Guoxuan")'s first large-scale energy storage power station project supplied overseas, the 1...[Details]
The Internet of Vehicles "builds the foundation" and digitalization "builds intelligence". The vehicle-road-cloud integrated autonomous driving solution created by China Unicom Zhiwang Technology has...[Details]
With the advancement of computer technology and network communication technology, the establishment of distributed networked test systems, improving test efficiency and sharing information resources h...[Details]
Nintendo released its 79th report, announcing the company's software and hardware sales and annual financial revenue from April 1, 2018 to March 31, 2019. It is reported that Nintendo's total sales f...[Details]
The MTS-5882 is a portable test device designed to make the daily work of enterprise technicians easier and improve the reliability of the power grid. This compact tester helps substation technicians...[Details]
LED, also known as Light Emitting Diode, is a semiconductor component.
Since 1962, when General Electric Company of the United States developed the world's first practical red light LED, L...[Details]
0 Introduction
The load with impact (rapid change) power in the power system will cause the voltage fluctuation and flicker of the power grid, causing many electrical equipment to fail to ...[Details]
Working principle: The three-phase air switch on the platform, the intermediate relay is closed. Press the K2 normally open button, K2 is self-locked, and the AC contactor K is closed. If the A pha...[Details]
Explosion = danger, it has almost become a consensus among people. But a German company wants to use explosion to provide safety for your electric car . With the development of electric vehicles, mor...[Details]
1. The electromagnetic flowmeter has no display 1. Check whether the power is on; 2. Check whether the power fuse is intact; 3. Check whether the power supply voltage meets the requirements; 4. Check...[Details]
As we all know, the output power of a DC power source is P=UI, and the power consumed is Pt=UIt. If we want to charge for a DC power source, we only need to evaluate the AC voltage, DC current and po...[Details]
Solar energy generally refers to the radiant energy of sunlight, which is generally used for power generation in modern times. Since the formation of the earth, organisms have mainly survived by th...[Details]
GD32 MCU
京公网安备 11010802033920号
EEWORLD
