The interface of the three-phase DC brushless controller is shown in the figure.The control port (left side) has a hole spacing of 2.0:5V - the control board outputs 5V internally, which can provide a...
In embedded development, we sometimes need to check the usage of the target chip FLASH and RAM area after compilation. Most IDEs disable this function by default. In this case, we can manually enable ...
Recently, I used a circuit like the one below, which uses a 5551 to control MJD127, and then controls the on and off of 36V.What I don't understand now is how to select the resistance value of R2 to m...