METALLIZED POLYESTER
PREFORMED CASE
X624
PAGE 5 OF 5
GENERAL SPECIFICATIONS
PHYSICAL CHARACTERISTICS
CONSTRUCTION:
NON-INDUCTIVE WOUND METALLIZED POLYESTER.
CASE:
PREFORMED CASE WITH EPOXY FILL.
LEAD MATERIAL:
SOLDER COATED OR TINNED SOLID WIRE, AWG AS SPECIFIED IN TABLES.
DIMENSIONS:
AS SPECIFIED IN TABLES
ELECTRICAL CHARACTERISTICS
CAPACITANCE:
AS SPECIFIED IN TABLES ± REQUESTED TOLERANCE WHEN MEASURED AT OR
REFERRED TO 1000 ± 20 HZ AND 25 ± 5 °C.
TOLERANCE:
±5%, ±10%, AND ±20% AVAILABLE. OTHER TOLERANCES AVAILABLE UPON REQUEST.
DISSIPATION FACTOR:
SHALL NOT BE GREATER THAN 1.0% WHEN MEASURED AT OR REFERRED TO
1000 ± 20 HZ AND 25 ± 5 °C.
INSULATION RESISTANCE:
SHALL BE GREATER THAN 15,000 MΩ FOR CAPACITANCE VALUES 0.33 µF
AND LESS OR 5,000 MΩ x µF FOR CAPACITANCE VALUES GREATER THAN 0.33 µF WHEN MEASURED
AFTER 1 MINUTE ELECTRIFICATION AT 100VDC AND 25 ± 5 °C.
DIELECTRIC STRENGTH:
160% RATED VOLTAGE FOR 2 SECONDS THROUGH A LIMITING RESISTANCE
OF 100 OHMS/VOLT AT 25 ± 5 °C.
RATED VOLTAGE:
100VDC, 250VDC, 400VDC, AND 630VDC AVAILABLE.
TEMPERATURE:
-40 °C TO +85 °C AT FULL RATED VOLTAGE OPERATIONAL, +105 °C MAX STORAGE
TEMPERATURE.
ADDITIONAL INFORMATION
ORDERING INFORMATION:
ALL ASC CAPACITORS ARE ORDERED BY "FAMILY CAP-TOL-VOLT"
DESIGNATION. BECAUSE MANY VALUES ARE AVAILABLE IN MULTIPLE CASE SIZES, CASE CODE MUST
ALSO BE INCLUDED IN PARENTHESIS AFTER THE FAMILY. (I.E. TO ORDER AN X624 0.1µF, ±10%,
100VDC CAPACITOR IN CASE SIZE B2, REQUEST PART NUMBER "X624(B2) .1-10-100")
SEE ALSO:
"GENERAL INFORMATION - POLYESTER CAPACITORS" DOCUMENT FOR ADDITIONAL
PHYSICAL, ELECTRICAL, AND PERFORMANCE CHARACTERISTICS NOT MENTIONED IN THIS FILE.
WARNING:
INFORMATION ON THIS FILE IS SUBJECT TO CHANGE WITHOUT NOTICE AT ASC'S
DISCRETION.
LAST MODIFIED: 08/30/01
Phone: (308) 284-3611
Fax: (308) 284-8324
301 WEST O STREET
•
OGALLALA, NE 69153
e-mail: sales@ascapacitor.com
web: www.ascapacitor.com