ATC GENERAL PURPOSE CAPACITORS: NPO (COG) DIELECTRIC
ELECTRICAL CHARACTERISTICS
CAPACITANCE RANGE:
0.5 pF to 0.10 µF.
TEMPERATURE CHARACTERISTIC:
0 ± 30ppm/°C.
L
W
OPERATING TEMPERATURE RANGE:
-55°C to +125°C.
DISSIPATION FACTOR:
0.1% (max.) @ + 25°C,
@1 MHz
≤
1000 pF; @1 KHz >1000 pF
INSULATION RESISTANCE
@ + 25°C and rated Vdc:
100,000 megohms (min.) or 1000 ohm-farads (min.),
whichever is less.
DIELECTRIC WITHSTANDING VOLTAGE:
250% of rated voltage for 5 ± 1 seconds, 50 milliamps (max.).
Unless otherwise specified all test data is at + 25°C.
T (MAX.)
MB
Temperature Coefficient
Aging Rate
Voltage Coefficient of Capacitance
Temperature (Celsius)
Impedance vs. Frequency
Dissipation Factor vs. Frequency
Minimum IR vs. Temperature
Temperature (Celsius)
Sales of ATC products are subject to the terms and conditions contained in American Technical Ceramics Corp. Terms and Conditions of Sale(ATC document #001-992 Rev. A 10/03). Copies of
these terms and conditions will be provided upon request. They may also be viewed on ATC's website at www.atceramics.com/productfinder/default.asp. Click on the link for Terms and
Conditions of Sale.
ATC has made every effort to have this information as accurate as possible. However, no responsibility is assumed by ATC for its use, nor for any infringements of rights of third parties which
may result from its use. ATC reserves the right to revise the content or modify its product without prior notice.
There is an RGB_LED on the AB32VG1 development board. The schematic diagram of the RGB_LED is shown in Figure 1, through which you can learn how to use GPIO.Figure 1 RGB_LED circuit
The pin connection...
[i=s]This post was last edited by bigbat on 2019-2-25 19:39[/i] I was very frustrated because of the failure of lwIP of stm32cubeMX. I saw the TCP/IP post by [url=home.php?mod=space&uid=374032]@54chen...
[i=s]This post was last edited by qwqwqw2088 on 2020-11-1 09:20[/i]Supercapacitors are becoming more and more popular in many applications due to their charging times, better transient performance, si...
This is my first time using DSP, and I don't know much about it. I found a few tutorials on porting the EMCV library, and followed them. But when I tested it, the program got stuck when it reached cvC...
module DSP_RST(input clk_25m, input RESETSTAT, //DSP reset status 0 means reset status 1 means working statusinput LOCKED, //Is the clock module normal?
output ref LRESETNMIENz = 1'b0,//局部复位管脚
output ...
Domestic Chip Exchange
京公网安备 11010802033920号
EEWORLD
