IP Rating ............................................................ IP 40 .....................................................................IP 40
*RoHS Directive 2002/95/EC Jan. 27, 2003 including annex and RoHS Recast 2011/65/EU June 8, 2011.
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
Model 91, 92, 93, 94 & 95 - 5/8 ” Square Single-Turn Panel Control
Mechanical Characteristics
1
Stop Strength (1/4 ” D shaft) .............................................................................................................................................45.19 N-cm (4 lb.-in.)
(1/8 ” D shaft) .............................................................................................................................................33.89 N-cm (3 lb.-in.)
Starting ........................................................................................................................................... 0.3 max. above average running torque
Running Torque
Single or Dual Section (A & R Bushings) .................................................................................................. 0.21 to 1.06 N-cm (0.3 to 1.5 oz.-in.)
Single or Dual Section (C & U Bushings) .................................................................................................. 0.14 to 1.06 N-cm (0.2 to 1.5 oz.-in.)
Mounting .............................................................................................................................................1.7-2.0 N-m (15-18 lb.-in.) maximum
Variation ...................................................................................................................... 0.35 N-cm (0.5 oz.-in.) maximum in 45 ° shaft travel
Weight (Single Section, Metal Bushing)...............................................................................................................................12.7 grams nominal
Terminals .................................................................................................................................Printed circuit terminals, J-Hooks or solder lugs
Soldering Condition ...........................................Recommended hand soldering using Sn95/Ag5 no clean solder, 0.025 ” wire diameter.
Maximum temperature 399 °C (750 °F) for 3 seconds. No wash process to be used with no clean flux.
Marking ..................................................................................Manufacturer’s trademark, date code, resistance, manufacturer’s part number
Ganging (Multiple Section Potentiometers).............................................................................................................................2 cups maximum
Hardware ...................One lockwasher and one mounting nut is shipped with each potentiometer, except where noted in the part number.
NOTE:
1
At
Performance specifications do not apply to units subjected to printed circuit board cleaning procedures.
room ambient: +25 °C nominal and 50 % relative humidity nominal, except as noted.
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
Model 91, 92, 93, 94 & 95 - 5/8 ” Square Single-Turn Panel Control
Product Dimensions
Model 91 PC Pin Terminals, In-Line
22.86 ± 0.43
(.900 ± .017)
MOUNTING
SURFACE
L
12.70 ± .229
(.500 ± .009)
0.79 ± .025
(.031 ± .010)
DIA.
13.72 ± 0.38
(.540 ± .015)
1.37 ± 0.08
(.054 ± .003)
2.36 ± 0.08
(.093 ± .003)
15.88
(.625)
7.92
(.312)
Model 92 J-Hooked
Terminals, In-Line
.79
(.031) 2 PLCS.
3 2 1
.254
(.010)
GAP
SEE
HOW TO ORDER
CHART FOR
BUSHING OPTIONS.
10.16 ± 0.30
(.400 ± .012)
11.05 ± 0.20
(.435 ± .008)
SEE
NEXT PAGE
FOR SHAFT
OPTIONS.
1.19
(.047)
“A” STYLE
A.R. LUG
R
9.53
(.375)
15.29 ± 0.56
(.602 ± .022)
5.08
(.20)
1.52
(.06)
R2
R1
1
2
3
1
2
3
2.54
(.100)
2.54
(.100)
Model 94 J-Hooked
Terminals, "L" Pattern
0.76 ± 0.05
(.030 ± .002)
TYP.
Model 93 PC Pin Terminals, "L" Pattern
22.86 ± 0.43
(.900 ± .017)
MOUNTING
SURFACE
L
12.70 ± .229
(.500 ± .009)
0.79 ± .025
(.031 ± .010)
DIA.
13.72 ± 0.38
(.540 ± .015)
1.37 ± 0.08
(.054 ± .003)
2.36 ± 0.08
(.093 ± .003)
15.88
(.625)
7.92
(.312)
3 2 1
1.52
(.06)
GAP
.81
(.032)
R. MAX.
5.33 ± .76
(.21 ± .03)
3.81
(.150)
MAX. TYP.
SEE
HOW TO ORDER
CHART FOR
BUSHING OPTIONS.
DIA.
0.81
TYP.
(.032)
10.16 ± 0.30
(.400 ± .012)
R2
R1
5.08 ± 0.38
(.200 ± .015)
11.05 ± 0.20
(.435 ± .008)
SEE
NEXT PAGE
FOR SHAFT
OPTIONS.
1.19
(.047)
“A” STYLE
A.R. LUG
R
9.53
(.375)
12.7 ± 1.02
(.500 ± .040)
Shaft Flat Orientation
2.54
(.100)
2.54
(.100)
120 ° ± 5 ° STD.
FLAT ORIENTATION
(SHAFT AT CCW END)
1
3
2
1
3
2
0.76 ± 0.05
(.030 ± .002)
TYP.
1
CCW
2
POTENTIOMETER
3
Model 95 Solder Lug Terminals, "Triangular" Pattern
1. Introduction The on-chip FLASH of MSP430F5438 can be used as EEPROM. This part of FLASH is called INFO FLASH. There are 4 blocks of 128Byte each. Although the capacity of INFO FLASH is relatively s...
Hall current sensor is a very common sensor in our daily life, which is widely used in household appliances, smart grid, electric vehicles, wind power generation, etc. As a high-tech product, it has a...
This book uses Xilinx's FPGA device as the development platform, and adopts MATLAB and VHDL language development tools to elaborate on the implementation principle, structure, method and simulation te...
You can do it without the baseboard, see the manual:TP23 SWDCLK, K64 and KW41 share TP22 K64's SWDIO TP24 KW41's SWDIO Test points are all reserved. Pry open the case, see the circuit board, look for ...
Nanning Advantech has launched its new product VAS5053 Audi and Volkswagen CAN bus diagnostic system after research and development. As K-line is gradually replaced by CAN bus, using CAN bus diagnosti...
It is not uncommon for improper isolation circuit design to cause equipment damage or even electric shock accidents. For this reason, the industry has proposed many safety isolation design performanc...[Details]
The MAXQ1740 is a low-power microcontroller that integrates a three-track magnetic stripe reader interface, an I²C interface, two SPI™ interfaces, and a universal synchronous/asynchronous receiver/...[Details]
1. What is the junction temperature of LED?
The basic structure of LED is a semiconductor PN junction. Experiments show that when current flows through an LED element, the temperature of the P...[Details]
AOKU, the world's leading 4D imaging radar company, today announced the launch of the world's highest angular resolution commercial 4D imaging radar - FALCON and EAGLE radar products. Using its AI al...[Details]
There are many types of probes. Differential probes are very common in switching power supply applications. Antai Testing will focus on the measurement of differential signals and provide you with de...[Details]
The BOE Wuhan 10.5-generation LCD production line visit and TV display technology tasting event with the theme of "Seeking the Source" was held in Wuhan. At a time when the current TV industry and ...[Details]
1. Don't define too many variables. The lower 128 bits are the storage area for user-defined variables (by default). You can also put variables in the upper 128 bits, but it is easy to make mistakes. ...[Details]
OFweek Cup 2022 China
Robot
Industry Annual Awards (abbreviated as OFweek Robot Awards 2022) is jointly organized by OFweek, China's high-tech industry portal, and its authoritative robo...[Details]
On May 9, at the first China International Smart Terminal Industry Development Conference, Xiong Delong, executive chairman of the China Committee of the Indonesian Chamber of Commerce and Industry, ...[Details]
The mid-term facelift Mercedes-Benz E-Class (W213) was released on March 3, 2020 Beijing time. Due to the spread of the "new coronavirus" epidemic, this year's Geneva Motor Show in Switzerland was fo...[Details]
Red Net News reporter Li Huifang reports from Changsha
By entering keywords, data such as power grid poverty alleviation, electricity consumption, and online power consumption can be clearly s...[Details]
1 Introduction
As human beings’ demand for energy increases day by day, the reserves of fossil energy on the earth are becoming increasingly depleted. Developing and utilizing renewable en...[Details]
Infineon Technologies Launches XENSIV™ TLE4972, a High-Precision Coreless Current Sensor for Automotive Applications
Munich, Germany - October 27, 2021 - Infineon Technologies AG int...[Details]
10.2.1 Oscillator Characteristics
XTAL1 and XTAL2 form the input and output of the inverting amplifier of the on-chip oscillator, respectively, as shown in Figure 10.3. The oscillator can be com...[Details]
Fifth-generation (5G) wireless infrastructure not only opens the way for new applications, but also greatly improves 4G and previous generations of wireless applications. As 5G network performance im...[Details]