Ordering Information .................................................................................................................................................................... 2
Device Configurations and Pin-outs ............................................................................................................................................. 9
Pin-out Top Views................................................................................................................................................................. 9
Test Circuit Diagrams for LVCMOS and Clipped Sinewave Outputs ......................................................................................... 10
Frequency Stability ............................................................................................................................................................. 16
Output Frequency and Format ............................................................................................................................................ 16
Output Frequency Tuning ................................................................................................................................................... 16
Pin 1 Configuration (OE, VC, or NC) .................................................................................................................................. 17
Control Voltage Bandwidth ................................................................................................................................................. 20
Pull Range and Average Pull Range .................................................................................................................................. 22
Output Frequency ............................................................................................................................................................... 23
I
2
C Control Registers .......................................................................................................................................................... 25
Serial Interface Configuration Description .......................................................................................................................... 28
Serial Signal Format ........................................................................................................................................................... 28
Parallel Signal Format ........................................................................................................................................................ 29
Parallel Data Format ........................................................................................................................................................... 29
I
2
C Timing Specification ...................................................................................................................................................... 31
I
2
C Device Address Modes ................................................................................................................................................. 32
Schematic Example ............................................................................................................................................................ 33
Dimensions and Patterns ........................................................................................................................................................... 34
Additional Information ................................................................................................................................................................ 36
Revision History ......................................................................................................................................................................... 36
Rev 0.52
Page 3 of 36
www.sitime.com
SiT5146
1 MHz to 60 MHz, ±0.5 to ±2.5 ppm, Endura™ Series Super-TCXO
Electrical Characteristics
PRELIMINARY
All Min and Max limits are specified over temperature and rated operating voltage with 15 pF output load unless otherwise
stated. Typical values are at 25°C and 3.3V Vdd.
Table 1. Output Characteristics
Parameters
Nominal Output Frequency Range
Operating Temperature Range
Symbol
F_nom
T_use
Min.
1
-20
-40
-40
Acceleration (g) sensitivity, Gamma
Vector
F_g
–
–
Typ.
–
–
–
–
Max.
60
+70
+85
+105
Unit
MHz
°C
°C
°C
Extended Commercial, ambient temperature
Industrial, ambient temperature
Extended Industrial, ambient temperature
Ultra-low sensitivity grade; total gamma over 3 axes; 15 Hz
to 2 kHz; MIL-PRF-55310, computed per section 4.8.18.3.1
Low sensitivity grade; total gamma over 3 axes; 15 Hz to
2 kHz; MIL-PRF-55310, computed per section 4.8.18.3.1
Referenced to (max frequency + min frequency)/2 over the
rated temperature range. Vc=Vdd/2 for VCTCXO
Condition
Frequency Coverage
Temperature Range
Rugged Characteristics
0.004
–
0.009
0.1
ppb/g
ppb/g
Frequency Stability
Frequency Stability over
Temperature
F_stab
-0.5
-1.0
-2.5
Initial Tolerance
Supply Voltage Sensitivity
F_init
F_Vdd
-1
-16.25
-32.50
-65.0
Output Load Sensitivity
F_load
-2.75
-5.50
-11.00
Frequency vs. Temperature Slope
ΔF/ΔT
-25
-50
-100
Dynamic Frequency Change during
Temperature Ramp
F_dynamic
-0.21
-0.42
-0.83
One-Year Aging
20-Year Aging
F_1y
F_20y
–
–
–
–
–
–
±7.10
±11.83
±28.40
±0.81
±1.35
±3.24
±15
±25
±60
±0.13
±0.21
±0.50
±1
±2
+0.5
+1.0
+2.5
+1
+16.25
+32.50
+65.0
+2.75
+5.50
+11.00
+25
+50
+100
+0.21
+0.42
+0.83
–
–
ppm
ppm
ppm
ppm
ppb
ppb
ppb
ppb
ppb
ppb
ppb/°C
ppb/°C
ppb/°C
ppb/s
ppb/s
ppb/s
ppm
ppm
Initial frequency at 25°C inclusive of solder-down shift
This book is one of the planned textbooks in the series of microelectronics and integrated circuit design. The whole book follows the full-custom design process of analog integrated circuits and intro...
Beijing Zhongke Xinruan sincerely recruits IGBT teachersWeekends are available. If you want to earn some extra money, accumulate resources, and enrich your life, please contact me. More than two years...
[i=s]This post was last edited by 怀穿少年梦 on 2021-7-29 12:04[/i]This time, we use ATGM332D GPS module to obtain the current time and positioning information. ATGM332D GPS module has dual-mode function, ...
1. Introduction to UWB
UWB is the abbreviation of Ultra Wide Band; UWB technology is a wireless carrier communication technology that uses a frequency bandwidth of more than 1GHz. It does not use a si...
Today MicroPython added the basic files for the PowerPC architecture, which is intended to run MicroPython in QEMU.https://github.com/micropython/micropython/tree/master/ports/powerpc...
Routine testing Most routine execution processes are:Reset_HandlerSystem_Core_Config()__main(), (compiler C runtime library heap, stack, initialization of variables with initial values, etc.)main()Sys...
Have you ever been driven crazy by your phone's battery dropping to 20% when you need it most? It is reported that the top ten most advanced breakthrough technologies can make your phone battery pe...[Details]
CO2 welding is an important welding method with the characteristics of high efficiency and low cost. The quality of traditional CO2 welding is limited by the welding power supply and control meth...[Details]
A new generation of collision detection and tracking technology will make collaborative robots safer around humans and other moving objects... Collision detection and tracking technologies from start...[Details]
Rechargeable batteries are widely used in industrial and agricultural production, national defense science and technology and other fields, and the detection and charging of rechargeable batteries ...[Details]
On July 12, Xiaopeng Motors' ecological enterprise "Xiaopeng Pengxing" announced the completion of the signing of the A round of financing, which exceeded 100 million US dollars. One of the leading i...[Details]
1. What is ripple?
Ripple is defined as
the AC component superimposed on the DC steady state in
a DC
voltage
or
current
.
It has the following main...[Details]
On September 17, Xie Qiu, general manager of AVIC Lithium's passenger vehicle business, delivered a keynote speech on thoughts on the development of power battery technology under the new pattern at...[Details]
Apple is looking to tap more Chinese suppliers to meet its iPhone 13 production targets, according to a new report from Nikkei Asia. According to a previous report by Nikkei, Apple's iPhone product...[Details]
Last week, Huawei officially released the Kirin 990 series chips at IFA2019. This series of chips includes Kirin 990 and Kirin 990 5G version. Regarding the latter, Li Nan, former senior vice preside...[Details]
Oscilloscope basic trigger mode The basic and widely used trigger mode is the standard edge trigger. This trigger allows you to trigger on the rising edge, falling edge, or both edges. Although the e...[Details]
Recently, Jucan Optoelectronics released information related to investor surveys, answering questions such as the operating highlights of the 2020 semi-annual report that has been released, the expan...[Details]
1. Alarm "20252" High temperature (DRV1 fault handling)
Solution: Check whether the motor is overheated. If the motor temperature is normal, check whether the connecting cable is normal (it ma...[Details]
1. Background When doing boost, the following circuit is used to sample the inductor current Use a current sensing resistor and an op amp differential circuit. As the current increases, the CT2 v...[Details]
Silicon controlled switch SCS (SILICon ControlLED Switch) is also called four-terminal low-power thyristor. It is a novel and multifunctional semiconductor device. As long as its wiring method is c...[Details]