This is a high-power PW device in the L bandAs shown in the pictureThe design requirements of the filter are also high powerThe picture belowScrewThere are traces of burns in the picture...
Today I tested the GNSS function on Beetle ESP32-C3. The GNSS is VK2828, Beidou + GPS dual-mode, and the positioning speed is relatively fast.The power supply of GNSS is directly from 3.3V on Beetle E...
PrefaceThis application note mainly describes a case of implementing a simple HDMI CEC transceiver function based on AT32 GPIO and timer peripherals.Consumer electronic control (CEC) isa function of t...
Develop a DSP board, containing two TMS320C6455 chips and a Xilinx FPGA XC5VLX85-FF668. The peripherals include(1) IO expansion chip MAX6957, 5V, connected to FPGA through 74LVC16T245; (2) UART, RS-42...
1. Purpose
The microphone array is arranged in an array to focus on picking up the sound signal in the space, so that the picked up sound is enhanced and the effect of long-distance sound pickup is ac...
Help
I want to make a boost and buck circuit, but there is no buck. How to fix it?
As a result, the output pin voltage is the same as the input pin voltage, both are 3V...