ATC GENERAL PURPOSE CAPACITORS: NPO (COG) DIELECTRIC
ELECTRICAL CHARACTERISTICS
CAPACITANCE RANGE:
0.5 pF to 0.10 µF.
TEMPERATURE CHARACTERISTIC:
0 ± 30ppm/°C.
L
W
OPERATING TEMPERATURE RANGE:
-55°C to +125°C.
DISSIPATION FACTOR:
0.1% (max.) @ + 25°C,
@1 MHz
≤
1000 pF; @1 KHz >1000 pF
INSULATION RESISTANCE
@ + 25°C and rated Vdc:
100,000 megohms (min.) or 1000 ohm-farads (min.),
whichever is less.
DIELECTRIC WITHSTANDING VOLTAGE:
250% of rated voltage for 5 ± 1 seconds, 50 milliamps (max.).
Unless otherwise specified all test data is at + 25°C.
T (MAX.)
MB
Temperature Coefficient
Aging Rate
Voltage Coefficient of Capacitance
Temperature (Celsius)
Impedance vs. Frequency
Dissipation Factor vs. Frequency
Minimum IR vs. Temperature
Temperature (Celsius)
Sales of ATC products are subject to the terms and conditions contained in American Technical Ceramics Corp. Terms and Conditions of Sale(ATC document #001-992 Rev. A 10/03). Copies of
these terms and conditions will be provided upon request. They may also be viewed on ATC's website at www.atceramics.com/productfinder/default.asp. Click on the link for Terms and
Conditions of Sale.
ATC has made every effort to have this information as accurate as possible. However, no responsibility is assumed by ATC for its use, nor for any infringements of rights of third parties which
may result from its use. ATC reserves the right to revise the content or modify its product without prior notice.
I'm going to use the MP2307DN to make a 2A, 5V circuit. I found an old schematic and it's a proven circuit! It works, but when I opened the "datasheet", I found the circuit diagram was like this.
Ther...
As shown in the picture, when I change the voltage, the current remains unchanged, but when I change the resistance of R2, the current changes. Why is that?...
[i=s]This post was last edited by lugl4313820 on 2022-1-22 15:14[/i]N32G45XVL-STB Unboxing + LightingI am very grateful to the judges of the eeworld development board evaluation project for their trus...
After a quick look at the official GD examples, I feel that they still maintain the general structure of the ST official examples. Anyone who has done ST development can easily understand them. They a...
The official lighting program is just a flowing light. Let's try something a little more complicated, a breathing light.The simple principle of the breathing light is to use PWM wave to drive the LED,...