1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3. Phase noise degrades with increasing output frequency.
4. Subject to technical modi cation.
5. Contact factory for availability.
For Additional Information, Please Contact
USA:
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
Europe:
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 3328.4784.17
Fax: +49 (0) 3328.4784.30
Asia:
Vectron International
1F-2F, No 8 Workshop, No 308 Fenju Road
WaiGaoQiao Free Trade Zone
Pudong, Shanghai, China 200131
Tel: 86.21.5048.0777
Fax: 86.21.5048.1881
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
What technology did ZigBee originate from?
In the process of using Bluetooth technology, people found that although Bluetooth technology has many advantages, it still has many defects. For the field...
[i=s]This post was last edited by Popular Technology on 2021-11-17 23:17[/i]It's been a few days since I got the board. I tested the RGB dot screen these days. Because the development board itself doe...
Question: What is the accuracy deviation of the charging current set by BQ24133? ? For example, I use a 1% accuracy resistor to limit the charging current to 2.21A. If the voltage division does not ch...
[i=s]This post was last edited by chenzhufly on 2019-5-26 18:07[/i] I am the author of this trial, my name is Chen Changhao, a third-grade freshman.My little work today is to try the LED matrix to dis...
From the perspective of the project, the first step in project development is demand analysis. From the perspective of the product's life cycle cost (LCC), the project establishment and demonstration ...
A reference design for a 24VAC powered UART to Wi-Fi bridge targeting building automation and HVAC systems. The design features a low-power SimpleLink Wi-Fi CC3200 wireless MCU for Internet connectivi...
What new technologies are being used to combat the novel coronavirus outbreak? How can these emerging technologies be used to track the outbreak, prevent its spread, or treat infected patients? In ...[Details]
Medtec Medical Device Design and Manufacturing Technology Exhibition announces new schedule in the New Year: Suzhou International Expo will set sail in full force on June 1, 2023 Under the guidance...[Details]
The mortality rate of pancreatic cancer is much higher than that of most other cancers. Most current pancreatic cancer diagnostic technologies rely on the detection of a specific protein, CA19-9, in ...[Details]
Accelerate the breakthrough of core technologies for intelligent vehicles After BYD completed its strategic investment in Horizon Robotics, an automotive smart chip company, Horizon Robotics and B...[Details]
1. CPSR Definition
31 30 29 28 27 7 6 5 4 3 2 1 0
N Z C V Q I F T M4 M3 M2 M1 M0
N: The 31-bit value of the result of the current instruction operation. When a signed number is operated, N=1 indi...[Details]
The dramatic incident at Pride actually reflects the great changes and developments in the design and manufacturing of the entire battery system from 2017 to now. I would like to take a closer look a...[Details]
HMC1022: The sensor is a four-arm Wheatstone bridge that converts the magnetic field into a differential output voltage.
. Sensitivity is 1mV/V/Gauss
. Wider magnetic field range: ±6 microgauss (geo...[Details]
When the Tesla Roadster went into production in 2008, owners were promised more than 210 miles of range per charge. Now, more than a decade later, the upcoming version nearly triples that promise. B...[Details]
China's electric vehicle battery production giants CATL and BYD are "going global". Recently, some media reported that the two companies may soon meet in the Japanese market. CATL will launch batteri...[Details]
In recent years, due to the advancement of technology and efficiency, the application of LED has become more and more extensive; with the upgrading of LED applications, the market demand for LED has ...[Details]
On July 3, 2024,
WPG Holdings, a leading international semiconductor component distributor dedicated to the Asia-Pacific market, announced that its subsidiary WPI has launched a 4.5W non-isolat...[Details]
1 Introduction Ethernet has evolved rapidly and has become the de facto choice for wired networks, which are used in a wide range of markets, from home, office, enterprise to industry, and automobi...[Details]
Samsung is gearing up to launch the next generation of Galaxy S series phones in January, and in addition to the flagship product, the company may also launch a new tracker. Now, 91Mobiles has discov...[Details]
It is often assumed that components of electric vehicles would be state-of-the-art, and charging barriers are no exception. After all, charging a car is a frequent, daily necessity. Charging operat...[Details]
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
