CTDD1906SF-2412-S3K-1

In the digital control system composed of 51 single-chip microcomputer, PID controller is realized by PID control algorithm. 51 single-chip microcomputer collects signals through AD and converts them ...[Details]

The stepper motor is an open-loop control element that converts electrical pulse signals into angular displacement or linear displacement. In the case of non-overload, the motor's speed and stop po...[Details]

On April 13, Huawei UK published an open letter on its official website, in which Huawei stated that since the new coronavirus hit the UK, data usage has soared by 50% or more, which has put tremendo...[Details]

1 Introduction LED display technology has evolved from monochrome displays in the early 1980s to dual-primary-color displays in the late 1980s, to three-primary-color (full-...[Details]

//ccr = 0~499 void setPWM1(unsigned short ccr){//PC1   TIM1_CCR1H = (unsigned char)(ccr 8);   TIM1_CCR1L = (unsigned char)(ccr & 0xff); } void setPWM2(unsigned short ccr){//PC2   TIM1_CCR2H = (unsig...[Details]

　　With 51 single-chip microcomputer P89V51RD2 as the main controller, ROK101008 as the Bluetooth module, W3100A as the TCP/IP hardware protocol stack, and Ethernet network card chip RTL8201 as the ne...[Details]

After the release of iPadOS, Microsoft promised that the trackpad and mouse functions of iPadOS would be used in the Office suite. Recently, these two very practical functions have been updated. Micr...[Details]

At the I/O Developer Conference held earlier this month, Google previewed the upcoming Pixel 7 and Pixel 7 Pro. Judging from the official renderings of the back, the camera module design of the Pixel...[Details]

The Pangu large model mainly helps autonomous driving improve data closed loop. Huawei's Pangu large model begins to enable autonomous driving. Recently, at the Huawei Cloud Intelligent Driving I...[Details]

Members of the Automated Driving Computing Consortium include General Motors, Toyota, Denso, Continental, Bosch and NXP. According to foreign media reports, at the Arm TechCon 2019 conference held...[Details]

1. SCL is always controlled by the Master. SDA is controlled by the Slave when reading data and by the Master when writing data according to the direction of data transmission. After the 8-bit data i...[Details]

XTAL1 and XTAL2 are the input and output of the inverting amplifier of the on-chip oscillator, as shown in Figure 13. This oscillator can be used with either a quartz crystal or a ceramic resonator. ...[Details]

Designing a high-performance, flexible, and compact communication architecture on an FPGA is a huge challenge. Most FPGA-based NoCs run on a single clock. With the development of FPGA technology,...[Details]

There is a DOS software "Hex2bix.exe" in Cypress, which is said to be able to directly convert hex files into iic files. I don't know if it's a computer problem or something else, but my machine alway...[Details]

PN8015 integrates PFM controller and 800V high avalanche capability intelligent power MOSFET. The output voltage can be adjusted from 3.3V to 24V through FB resistor. It is used for low-power non-i...[Details]