Standard Frequencies – see Page 5 for developed frequencies.
* Check with factory for availability of frequencies not listed.
Applications
Automotive Electronics
Mobile Multimedia/Infotainment
Car Navigation Systems
Internet of Things [IoT, IIot]
Microcontrollers and FPGAs
Wireless Communication
Ethernet/GbE/SyncE
Medical Electronics
Commercial Military & Aerospace
Description
CTS Model SA324 incorporates a low cost, high Q, small size quartz resonator specifically developed to operate
over extended temperature ranges for use in automotive electronics.
Ordering Information
Model
SA324
Frequency Code
[MHz]
XXX or XXXX
Mode of
Oscillation
F
Tolerance
@ +25°C
3
Temperature
Stability
5
Temperature
Range
G
Load
Capacitance
A
Packaging
R
Code
Frequency
Product Frequency Code
1
Code
1
X
2
3
5
Tolerance
±10ppm
±15ppm
±20ppm
±30ppm
±50ppm
Code
I
G
H
N
P
M
Code
X
2
3
5
6
7
Stability
±15ppm
±20ppm
±30ppm
±50ppm
±100ppm
±150ppm
Temp. Range
-40°C to +85°C
2
-40°C to +105°C
3
-40°C to +125°C
4
-40°C to +150°C
5
-55°C to +105°C
5
-55°C to +125°C
5
Packing
Code
3k pcs./reel
R
Code
F
T
Mode
Fundamental
3rd Overtone
Code Capacitance Code Capacitance
7pF
16pF
V
C
8pF
18pF
K
D
9pF
20pF
J
E
10pF
24pF
A
F
12pF
30pF
L
G
13pF
Series
B
S
Notes:
1]
2]
3]
4]
5]
Refer to document 016-1454-0, Frequency Code Tables. 3-digits for frequencies <100MHz, 4-digits for frequencies 100MHz or greater.
Available with all stability codes.
Available with stability codes 3, 5, 6 and 7.
Available with stability codes 5, 6 and 7.
Stability codes 6 and 7. Contact factory for code 5 availability.
Not all performance combinations and frequencies may be available.
Contact your local CTS Representative or CTS Customer Service for availability.
This product is specified for use only in standard commercial applications. Supplier disclaims all express and implied warranties and liability in connection with any use of this
product in any non-commercial applications or in any application that may expose the product to conditions that are outside of the tolerances provided in its specification.
Several states of microcontroller IO port output1. What are the differences between the open-drain output and open-drain multiplexed output of a microcontroller?2. What are the differences between the...
As shown in the figure below, when I import the BOM, there are obviously many components with different values. Why are they not distinguished? If I want to separate them, how should I do it? Please h...
msp430f5529 capture plus serial port, which can be used for everyone to learn the microcontroller source program is as follows: #include "msp430f5529.h" #define uint unsigned int #define uchar unsigne...
[i=s]This post was last edited by freeelectron on 2019-10-14 17:15[/i]You can replace it with sensors, NBIOT, WIFI development boards, etc. If you like it, please contact us.
The above are all officia...
A long time ago, when I was still using Turbo C 2.0 to write programs, I saw setjmp() and longjmp() functions when browsing library functions in the help function, but I never understood what they wer...
Sleep current measurement The closed-circuit current may be too high in the vehicle occasionally or for a long period of time. This may be caused by a fault in the control unit. Since disconnecting...[Details]
Three structures are defined in the STM32 firmware library to correspond to these three register groups. The correspondence between these three structures and the registers in the ARM manual is as fol...[Details]
Abstract: The smart home monitoring and control system uses nRF905 to form a wireless network, connecting each unit and the main control unit for unified control, realizing home security control, amb...[Details]
Here is the schematic diagram of a 6-10W stereo power audio amplifier with IC TDA2005:
Components List:
This is a Class AB stereo audio power amplifier designed for high quali...[Details]
On November 13, according to Taiwan Economic Daily, mature wafer foundry process manufacturers are facing a battle to defend their capacity utilization rate of 60%. It is said that in order to save p...[Details]
Set the multimeter to R×1k. For PNP tubes, connect the black test lead to the emitter E, the red test lead to the base B, and connect the forward voltage to the emitter. The forward voltage of the ...[Details]
Introduction
This article is an interpretation of the selected paper RLAfford: End-to-end Affordance Learning for Roboc Manipulation, which was selected by ICRA 2023, a top international a...[Details]
1 Basic principles
Photoelectric direction finding refers to the use of photoelectric systems to determine the direction of a target. This is an important component of optical radar and optical...[Details]
"Requirements and test methods for electromagnetic compatibility of drive motor systems for electric vehicles" (GB/T 36282-2018) is a national standard of the People's Republic of China implemented...[Details]
Strictly speaking, 48V, HEV, PHEV (including EREV) are the only way for the entire internal combustion engine to move forward. As mentioned at the TEDA Forum, the supply of positive credits in the sh...[Details]
;;==============================================================================
;; Power On Reset Area
;;==============================================================================
Res...[Details]
Grid security is the foundation of modern society. Only when the grid operates safely and stably can it fulfill its mission and provide power support for boosting domestic demand and maintaining gr...[Details]
Intel creates chip-level enhanced hardware virtualization capabilities for the automotive industry to help build software-defined cars With Intel's market-leading chip-level enhanced hardware virtu...[Details]
The TCP0020, TCP2020 and TCP202A are a family of easy-to-use, high-performance AC/DC current probes designed for use with a variety of oscilloscopes. The TCP0020 design uses the TekVPITM probe interf...[Details]
cost:
The short-term growth of automotive LiDAR is highly certain, and the cost is continuing to fall. The transceiver module accounts for the majority of the BOM cost of LiDAR, and the transc...[Details]