This is a voltage follower circuit. The circuit input is 0-10V (10K ohm variable resistor), the power supply is 0-15V (single power supply), and the op amp is LM358. My friend said this is the worst o...
Job Description:
1. Responsible for the design, debugging and verification of UWB wireless RF transceiver (RX/TX) ;
2. RF direction includes but is not limited to the following modules: LNA , Mixer , ...
[size=4]When it comes to STM32's FLSAH, our first reaction is that it is used to install programs. In fact, STM32's on-chip FLASH is not only used to install programs, but also to install chip configu...
Live Topic: Develop AI intelligent robots based on TI's newly released Robotics SDKContent introduction:This webinar focuses on the newly released Robotics SDK from TI, including the components, frame...
[i=s]This post was last edited by CokezzZ on 2021-7-15 09:13[/i]It's OK to play with single-chip microcomputers and drive all peripherals, but if you are asked to write a complete set of code, there i...