EEWORLDEEWORLDEEWORLD

Part Number

Search

OC-160-BAF-107BA-5MHZ

Description
HCMOS Output Clock Oscillator, 5MHz Nom,
CategoryPassive components    oscillator   
File Size60KB,2 Pages
ManufacturerMicrosemi
Websitehttps://www.microsemi.com
Download Datasheet Parametric View All

OC-160-BAF-107BA-5MHZ Overview

HCMOS Output Clock Oscillator, 5MHz Nom,

OC-160-BAF-107BA-5MHZ Parametric

Parameter NameAttribute value
MakerMicrosemi
Reach Compliance Codecompli
Ageing1 PPM/YEAR
Frequency Adjustment - MechanicalNO
frequency stability0.1%
Frequency Stability - Voltage0.002 ppm
input power2.5 W
Installation featuresTHROUGH HOLE MOUNT
Nominal operating frequency5 MHz
Maximum operating temperature85 °C
Minimum operating temperature-40 °C
Oscillator typeHCMOS
Output load100 KOHM, 10 pF
Oven power supply voltage12V
physical size36.07mm x 27.18mm x 19.3mm
Nominal supply voltage12 V
surface mountNO
Preheating power6 W
Maximum warm-up time30 Minute
Oven Controlled Crystal Oscillators (OCXO’s)
OC-160 Series (CO-730C)
Description:
The OC-160 Series offers low aging and excellent stability
options with quick warm-up performance with a standard
European CO-08 footprint.
Features:
Frequencies: 5, 10, 12.8, 13, 16.384, 19.44, 20, 20.48 MHz
European CO-08 Package
Excellent Temperature Stability
Superior Aging Characteristics
Very Fast Warm-up
Performance Characteristics
Parameter
Standard
Frequencies:
Package Size:
Supply Voltage:
Input Power:
Output Type:
Output Level (HCMOS):
Rise/Fall Time tr/tf (HCMOS):
Symmetry (Duty/Cycle,HCMOS):
Harmonics/subs:
Spurious:
Temperature Stability:
Characteristics
5, 10, 12.8, 13, 16.384, 19.44, 20, 20.48 MHz, Available 1 MHz to 80 MHz
35.3 x 26.9 x 19.4 mm (1.4” x 1.06” x 0.76”)
A:
15 Vdc ±5%
B:
12 Vdc ±5%
C:
5 Vdc ±5%
<6W turn-on (-20
o
C/70°C);
A:
HCMOS
<2.5W steady-state @ +25°C (-20°C/70°C)
K:
Sinewave ( >+10 dBm into 50 ohm)
Aging:
Short Term Stability (Allan Deviation):
Phase Noise (Typical @ 10 MHz):
Frequency vs. Supply:
Warm-up (Restabilization):
(Frequency relative to two hours after
turn-on following 24 hours off time
at +25
o
C with a maximum ambient
of <70
o
C)
Electrical Frequency Adjust:
Mechanical Configuration:
J:
Sinewave ( >+7 dBm into 50 ohm)
L:
Sinewave ( >+13 dBm into 50 ohm)
“0” <0. 5V, “1” >4.5V
(HCMOS)
<10 ns (10% - 90%)
(HCMOS)
50/50 ±10% (@50% level)
(HCMOS)
-20 dBc (reduced level sinewave, for optional output)
-70 dBc (for sinewave output)
B-308:
±3 x 10
-8 over
0/50°C
B-109:
±1 x 10
-9 over
0/50°C
D-508:
±5 x 10
-8 over
-20/70°C
D-509:
±5 x 10
-9 over
-20/70°C
Note: Tighter stability options
F-107:
±1 x 10
-7 over
-40/85°C
are available, contact factory.
F-108:
±1 x 10
-8 over
-40/85°C
A:
1 x 10
-8
/day, 2x10
-6
/year
B:
3 x 10
-9
/day, 1x10
-6
/year
C:
1 x 10
-9
/day, 3x10
-7
/year
D:
5 x 10
-10
/day, 1x10
-7
/year
5 x 10
-11
/second (with aging
A
or
B);
5 x 10
-12
/second (with aging
C
or
D)
With Aging:
A or B
Aging: C or D
10 Hz
-100 dBc/Hz
-120 dBc/Hz
100 Hz
-135 dBc/Hz
-140 dBc/Hz
1 kHz
-145 dBc/Hz
-145 dBc/Hz
10 kHz
-150 dBc/Hz
-150 dBc/Hz
50 kHz
-150 dBc/Hz
-150 dBc/Hz
2 x 10-9 per % change in supply (with Aging
A
or
B)
5 x 10-10 per % change in supply (with Aging
C
or
D)
With Aging:
A or B
Aging: C or D
-6
: 6 minutes 1 x 10
-6
: 2 minutes
1 x 10
1 x 10
-7
: 8 minutes 1 x 10
-7
: 2.5 minutes
3 x 10
-8
: 10 minutes 3 x 10
-8
: 3 minutes
3 x 10
-8
: 30 minutes 1 x 10
-8
: 4 minutes
10 x 10-6 typical range (with Aging
A or B)
2 x 10-6 typical range (with Aging
C
or
D)
Pins for PCB mounting
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Web: www.vectron.com
46
[Qinheng Trial] 2. Preparation for CH549EVT Operation
[i=s]This post was last edited by lising on 2019-6-21 19:32[/i]This experiment is mainly to establish a development environment for the CH549EVT development learning board under KEIL, and try to use "...
lising DIY/Open Source Hardware
A brief discussion on SSI interface technology and its application in audio processing
[size=4] With the widespread application of embedded systems, the demand for serial communication within the system is getting higher and higher, and the protocols for serial data transmission are als...
fish001 Microcontroller MCU
PCB source file: adapter board for LIS25BA bone vibration sensor, thanks to ST engineers~
This post coincides with Thanksgiving, and here comes another piece of useful information . Special thanks to the ST engineer for sharing.Download PCB source file:For more information and information:...
nmg MEMS sensors
Share BLE connection parameters and their setting points
1. Connection parametersThe connection parameters are Connection interval, Slave latency, and Supervisor timeout. Connection interval----1.25ms as unit, value range 6~3200 [i.e. 7.5ms~4s] PS: Mobile p...
Jacktang Wireless Connectivity
Photodiode Problems
I have seen many questions about photodiodes and related circuits on technical forums. I would like to share this with more colleagues. This knowledge is what all analog designers must know.   A typic...
Aguilera Analogue and Mixed Signal
Interesting animated tutorial "Principles of Dialogue Communication"
[align=left][color=rgb(51, 51, 51)][font=-apple-system-font, BlinkMacSystemFont, "][size=17px]Today I would like to introduce to you a cartoon tutorial produced by ZTE University - Principles of Dialo...
EE大学堂 Training Edition

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号