Figure 7. Standard PECL Output Configuration Figure 8. Single Resistor Termination Scheme
Resistor values are typically 140 ohms for
3.3V operation.
Resistor values are typically 84 ohms for 2.5V
operation.
The VCC6 incorporates a standard PECL output scheme, which are un-terminated emitters as shown in Figure 7. There are numerous application notes on
terminating and interfacing PECL logic and the two most common methods are a single resistor to ground, Figure 8, and a pull-up/pull-down scheme as
shown in Figure 9. An AC coupling capacitor is optional, depending on the application and the input logic requirements of the next stage.
LVDS Application Diagrams
V
CC
LVDS
Driver
100
LVDS
Receiver
LVDS
Driver
100
Receiver
OUT+
OUT-
Figure 10 Standard LVDS
Output Configuration
Figure 11. LVDS to LVDS Connection, Internal 100ohm
Figure 12. LVDS to LVDS Connection
Some LVDS structures have an internal 100 ohm resistor on the
External 100ohm and AC blocking caps
input and do not need additional components.
Some input structures may not have an internal 100 ohm
resistor on the input and will need an external 100ohm
resistor for impedance matching. Also, the input may have
an internal DC bias which may not be compatible with
LVDS levels, AC blocking capacitors can be used.
One of the most important considerations is terminating the Output and Complementary Outputs equally. An unused output should not be left un-termi-
nated, and if one of the two outputs is left open it will result in excessive jitter on both. PC board layout must take this and 50 ohm impedance matching
into account. Load matching and power supply noise are the main contributors to jitter related problems.
The ESP32-Audio-Kit development board is a development board that focuses on audio processing. If it is equipped with a picture display function, it will be icing on the cake. Given that the interface...
[i=s]This post was last edited by landeng1986 on 2021-5-18 22:50[/i]The EVK-NINA-B400 evaluation kit was delivered during the 51 period, but I didn't have time to look at it. I went on a long business...
Author: Yuan TanApplication of isolation amplifier in motor drive:
A motor drive is a controller used to control various motors, such as AC inverters and servo motors. Generally, the motor is controll...
The slowdown of 4G is not 5G’s fault, at least not entirely.
Recently, the 4G network experience has become less and less satisfactory.
At a certain time or place, web pages often become difficult to ...
Tighter product tolerances, more complex manufacturing processes, and more demanding technical specifications make it harder to achieve the expected quality and more difficult to test. With accurate t...
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
