-
The problem of LCD screen flickering is a common problem in the production and design of electronic products. TOPWAY technical support team, relying on years of accumulated technical experience, ha...[Details]
-
In 2018, the global photovoltaic installation capacity was about 103.3GW. IHS Markit analyst EnergyTrend believes that the global photovoltaic installation data in 2019 will only be higher than that i...[Details]
-
Toyota has recently been granted a patent for an autonomous refueling/charging drone system that can drive to your location and fill your car with gasoline, hydrogen fuel, or electricity like a milit...[Details]
-
As hybrid vehicle technology has developed to this day, many manufacturers have come up with excellent solutions, ranging from mild hybrid to plug-in hybrid, from compact family cars to super sports ...[Details]
-
1. Inductor detection: Set the multimeter to R×1, and connect the red and black test leads to any lead-out terminal of the inductor. The pointer should swing to the right. According to the measured...[Details]
-
1. Use of ATMEGA16 I port: (only one experiment, each section below may have several experimental verifications, you know) 1--(01)--Use of 4*4 matrix push button switch I/O port introduction: Jus...[Details]
-
SLE4428 card reading and writing program. This EMC instruction version is rewritten according to the C51 program. It has passed the debugging. ;============================= ;Send data subroutine ;Ent...[Details]
-
Ultrasonic tooth cleaning machines have been widely used in the medical field. Most ultrasonic tooth cleaning machines used at home and abroad now use analog oscillation circuits. There are the fol...[Details]
-
The combination of human cognition and artificial intelligence (AI) marks the beginning of the fifth industrial revolution. In this era, humans and robots work together to promote social progress....[Details]
-
Requirements: 51 single-chip microcomputer, 8 buttons, 8 light-emitting diodes.
;When a key is pressed, the corresponding light turns on and goes out after 3 seconds. Each key controls one light.
...[Details]
-
(I) Basic introduction to industrial field bus CAN and introduction to STM32 CAN module First, read the documents about CAN in the manual, and read them carefully. STM32F10xxx Reference Manual Rev7V...[Details]
-
The intelligent pressure transmitter consists of two parts: an intelligent sensor and an intelligent electronic board. The intelligent sensor part includes: capacitive sensor, measurement diaphragm...[Details]
-
How to use the resistance level to measure whether a circuit is grounded? First, no matter what line or equipment is being measured, the voltage must be measured to ensure that it is safe and voltage...[Details]
-
The method of measuring voltage with a multimeter is to first align the range switch within the five ranges marked V (when testing AC voltage, align it with the AC voltage range, and when testing DC ...[Details]
-
With the support of AI, a new round of cockpit revolution is ready to take off.
Since December last year, Ideal Auto has started to push OTA5.0 in batches. The multimodal cognitive mod...[Details]