-
Continental has just released an innovative product in the HUD field: AR-HUD hyper-realistic head-up display technology, which vividly displays the surrounding information of the vehicle on ...[Details]
-
Class A amplifiers are amplifiers in which no power output element of the amplifier will experience current cutoff (i.e. stop output) during the entire cycle of the signal (positive and negative ha...[Details]
-
Due to the design of the hotel, the smart speaker and the controlled device are directly blocked, for example: the speaker is in the room and the temperature control panel is at the door. There are...[Details]
-
If the devices controlled by the microcontroller tend to be complex, it will be clearer to write the program using the state machine mode. However, the state machine diagrams on the Internet are diff...[Details]
-
DC current part: The moving coil should be installed correctly, and there should be no ferromagnetic material in the moving gap. If the shunt resistor is burned out, it should be replaced according t...[Details]
-
On November 29, China Energy Construction Yunnan Institute won the bid for the "14th Five-Year Plan" secondary system planning and design of Yunnan Power Grid Company.
The plan aims to impleme...[Details]
-
With the rapid development of computer technology, microelectronics technology and network technology, embedded systems have been widely used in many fields such as industry and agriculture. This a...[Details]
-
OFweek Cup · OFweek 2023 China
Robot
Industry Annual Selection (abbreviated as OFweek Robot Awards 2023) is jointly organized by OFweek, China's high-tech industry portal, and its authorita...[Details]
-
Apple today announced the end of a program that offered free logic board repairs to customers with potentially defective iPhone 8 models, MacRumors reports. In some cases, a faulty logic board can ca...[Details]
-
I've been developing with STM32F107 recently, and used CUBEMX to configure UART as the serial port to communicate with the host computer. However, I have been unable to receive data. I debugged it fo...[Details]
-
The 51 microcontroller is a commonly used microcontroller chip that is widely used in the control and calculation of various electronic devices. The crystal oscillator is very important in the microc...[Details]
-
Start signal (clock line is high, data line changes from high to low):
void AT24C04_Start()
{
SDA = 1; //Pull up the data line
SCL = 1; //Pull up the clock line
Delay5us(); //Delay...[Details]
-
//Based on the flash reading and writing of msp430F149 MCU, record the running status of 430,
//Restore the original operating state in case of reset and power failure.
#include msp430x14x.h
#in...[Details]
-
Regarding KUKA torque monitoring: the variable $TORQMON can be used to monitor the range and alarm.
$TORQMON Torque monitoring channel in program mode, torque monitoring in program mode.
...[Details]
-
introduction
Many electronic devices require a high-precision, high-current, regulated and adjustable DC power supply. This article introduces a general-purpose low-power regulated ...[Details]
Talking
京公网安备 11010802033920号
EEWORLD