HIN(U,V,W) and LIN(U,V,W) (Low side and high side control pins, Pin 7 - 12) ................................................ 5
VFO (Fault-output and NTC, Pin 14) ................................................................................................................. 6
ITRIP (Over current detection function, Pin 15) ................................................................................................ 6
VDD, VSS (Low side control supply and reference, Pin 13, 16) ....................................................................... 6
VB(U,V,W) and VS(U,V,W) (High side supplies, Pin 1 - 6) ............................................................................... 6
NW, NV, NU (Low side emitter, Pin 17 - 19) ..................................................................................................... 6
W, V, U (High side emitter and low side collector, Pin 20 - 22) ........................................................................ 6
P (Positive bus input voltage, Pin 23)................................................................................................................ 6
Absolute Maximum Ratings................................................................................................................................... 7
Mechanical Characteristics and Ratings ............................................................................................................ 11
Circuit of a Typical Application ........................................................................................................................... 12
Switching Times Definition .................................................................................................................................. 12
Flying probe test: Use probes to replace the bed of nails, and use multiple motor-driven, fast-moving electrical probes to contact the pins of the device and perform electrical measurements.During the...
Many analog circuits require a clock signal or require a task to be performed after a certain amount of time. For such applications, there are a variety of solutions available. For simple timing tasks...
The crystal oscillator and capacitors in the TaunchPad G2 kit are used to build an external clock circuit. If they are directly soldered to the board without modifying the original jumpers on the boar...
[i=s]This post was last edited by wadeRen on 2022-2-17 22:32[/i] # GD32L233C-START Review——05.SPI Test—Driving TFT Screen# [Article Navigation] [GD32L233C-START Review——01.Unboxing, Development Kit](h...
PCB Design
京公网安备 11010802033920号
EEWORLD
