485 communication mode, when the TTL end can reach 9600 baud rate, how many subtle rising edges can be accepted without data distortion? Using STM32F10 series MCU...
[i=s]This post was last edited by Buyixin on 2019-9-7 11:38[/i]Support the Master's Observation Room,
I'm just posting this, does this picture meet the requirements of this section?
Tianxj01, a netize...
Abstract: This paper introduces a copyright protection method for the hardware design of electronic products. It uses a special hardware security chip to embed into the product design. Through the met...
Article author: gaosi Article source: Mobile 3G website www.Goes3G.com/ Free WAP sites have gradually become a hot topic. In these sites, all resources including ringtones, games, dating, videos, and ...
Gpio module:
GPADIR determines whether it is input or output open-drain (open-drain) and push-pull (push-pull)GPAMUX selects the function pinGPADIR direction registerGPACTRLGPAQSEL
1. GPxMUX registerg...
Introduction Strain gauge sensors are widely used. They use a bridge circuit structure to improve output sensitivity. However, the output of a micro-strain bridge is only about 2 mV. Even under full l...