1 mm Straight, Surface Mount, With Power Ground Option
•
•
•
•
PK10M Series
1 mm pitch connector system
Four mating heights available
Available power contacts rated at 5A
Available frame ground connection through
surface mount retention clips
• Keyed design helps prevent mating
misalignment
• See Regulatory Information Appendix (RIA)
for chemical compliance information
Date Modified: September 14, 2007
TS-1152-B
Sheet 1 of 3
Physical
Insulation
Material:
Glass Filled LCP
Flammability:
UL 94V-0
Color:
Black
Materials
Signal Contact:
Copper Alloy
Power Contact:
Copper Alloy
Retention Clips:
Copper Alloy
Contact Plating
Underplating:
120 µ" [ 3.0 µm ] Nickel
Wiping Area:
4 µ" [ 0.10
μm
] min. Gold
Solder Tails:
Gold Flash
Retention Clip Plating:
Tin Copper over 120 µ" [ 3.0 µm ] Nickel
Marking:
Polarity Identification, Lot Number
Electrical
Current Rating:
0.5 A per Signal Contact, 5 A Power Contact
Insulation Resistance:
1 × 10
3
MΩ min at 250 V
DC
Withstanding Voltage:
300 V
AC
for 1 minute
Environmental
Temperature Rating:
-55°C to +85°C
Process Rating:
Maximum
260°C
3M
Interconnect Solutions
http://www.3M.com/interconnects/
3M is a trademark of 3M Company.
For technical, sales or ordering information call
800-225-5373
3M
™
Pak 10 Media Socket
1 mm Straight, Surface Mount, With Power Ground Option
Socket with Power Contacts
Contact
Quantity
40
50
60
80
A
32.40
[1.276]
37.40
[1.472]
42.40
[1.669]
52.40
[2.063]
B
32.00
[1.260]
37.00
[1.457]
42.00
[1.654]
52.00
[2.047]
C
29.40
[1.157]
34.40
[1.354]
39.40
[1.551]
49.40
[1.945]
D
25.40
[1.000]
30.40
[1.197]
35.40
[1.394]
45.40
[1.787]
E
22.40
[0.882]
27.40
[1.079]
32.40
[1.276]
42.40
[1.669]
F
20.80
[0.819]
25.80
[1.016]
30.80
[1.213]
40.80
[1.606]
G
19.00
[0.748]
24.00
[0.945]
29.00
[1.142]
39.00
[1.535]
PK10M Series
Ordering Information
PK10M - XXXSX - SMT - DA
(RIA E1 & C1 apply)
Contact Quantity
See Table
P = With Power Contacts
Omit = Without Power Contacts
TS-1152-B
Sheet 2 of 3
3M
Interconnect Solutions
http://www.3M.com/interconnects/
3M is a trademark of 3M Company.
For technical, sales or ordering information call
800-225-5373
3M
™
Pak 10 Media Socket
1 mm Straight, Surface Mount, With Power Ground Option
Socket without Power Contacts
Contact
Quantity
40
50
60
80
A
30.40
[1.197]
35.40
[1.394]
40.40
[1.591]
50.40
[1.984]
B
30.00
[1.181]
35.00
[1.378]
40.00
[1.575]
50.00
[1.969]
C
27.40
[1.079]
32.40
[1.276]
37.40
[1.472]
47.40
[1.866]
D
24.60
[0.969]
29.60
[1.165]
34.60
[1.362]
44.60
[1.756]
E
22.40
[0.882]
27.40
[1.079]
32.40
[1.276]
42.40
[1.669]
F
20.80
[0.819]
25.80
[1.016]
30.80
[1.213]
40.80
[1.606]
G
19.00
[0.748]
24.00
[0.945]
29.00
[1.142]
39.00
[1.535]
PK10M Series
TS-1152-B
Sheet 3 of 3
3M
Interconnect Solutions
http://www.3M.com/interconnects/
3M is a trademark of 3M Company.
For technical, sales or ordering information call
800-225-5373
Regulatory Information Appendix
3M Electronic Solutions Division/Interconnect
EUROPE
Appendix E1: European Union RoHS
Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as
amended by EU Commission Decision 2005/618/EC.
This product is RoHS Compliant 2005/95/EC.
“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of
the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless
the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information
represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.
In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and
Buyer’s exclusive remedy will be in accordance with the Warranty stated below.
Appendix E2: European Union RoHS
Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as
amended by EU Commission Decision 2005/618/EC.
This product contains lead in the compliant pin area in excess of the maximum concentration value allowed but is
compliant by exemption under EU Commission Decision 2005/747/EC.
“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of
the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless
the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information
represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.
In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and
Buyer’s exclusive remedy will be in accordance with the Warranty stated below.
Appendix E3: European Union RoHS
Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment as
amended by Commission Decision 2005/618/EC.
This product contains lead in the solder tail area in excess of the maximum concentration value allowed.
Unless otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information
provided by third party suppliers to 3M.
In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and
Buyer’s exclusive remedy will be in accordance with the Warranty stated below.
Appendix E4: European Union RoHS
Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as
amended by EU Commission Decision 2005/618/EC.
This product contains decaBDE in the insulating material in excess of the maximum concentration value allowed but is
compliant by exemption under EU Commission Decision 2005/17/EC.
“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in excess of
the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/EC, unless
the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this information
represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.
In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and
Buyer’s exclusive remedy will be in accordance with the Warranty stated below.
RIA-2217B-b
CHINA
Appendix C1: China RoHS
Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits for
Certain Hazardous Substances in Electronic Information Products.
This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006, means
that the product or part
does not
contain any of the following substances in excess of the following maximum concentration
values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls
or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless otherwise stated by 3M in writing, this
information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.
In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability and
Buyer’s exclusive remedy will be in accordance with the Warranty stated below.
Appendix C2: China RoHS
Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits for
Certain Hazardous Substances in Electronic Information Products.
This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006, means that
the product or part
does
contain a substance, as detailed in the chart below, in excess of the following maximum concentration
values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium, polybrominated biphenyls
or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless otherwise stated by 3M in writing, this
information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.
The numerical reference in the symbol above should not be construed as a representation regarding the product’s life or an
extension of a product warranty. The product warranty is stated below. In the event any product is proven not to conform with
3M’s Regulatory Information Appendix, then 3M’s entire liability and Buyer’s exclusive remedy will be in accordance with the
product Warranty stated below.
Important Notice
All statements, technical information, and recommendations related to 3M’s products are based on information believed to be reliable, but the accuracy or completeness
is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability associated
with such use. Any statements related to the product which are not contained in 3M’s current publications, or any contrary statements contained on your purchase order
shall have no force or effect unless expressly agreed upon, in writing, by an authorized officer of 3M.
Warranty; Limited Remedy; Limited Liability.
This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase.
3M MAKES NO OTHER WARRANTIES
INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
If this product is defective within the
warranty period stated above, your exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M product.
Except
where prohibited by law, 3M will not be liable for any indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of
京公网安备 11010802033920号
EEWORLD
