-
What is the buzzer used for?
A buzzer is an electronic component that generates a continuous and sharp sound signal. It is usually composed of a diaphragm, an oscillation source, and a drive c...[Details]
-
//LPC2103, an ARM product of Zhou Ligong's company.
//Here, a backslash is used at the end of each line to indicate the top and bottom lines.
//As a whole, it is easy to modify, understand and set....[Details]
-
Usually, a digital multimeter can be used to determine whether a power module is good or bad. As shown in the figure below, connect the red probe of the digital multimeter to U/V/W and the black prob...[Details]
-
Energy is an important material basis for human survival and development, and low-carbon energy development is related to the future of mankind. Under the guidance of the new energy security strategy ...[Details]
-
The MAX17502 is a high-efficiency, high-voltage, synchronous step-down DC-DC converter that operates over a 4.5V to 60V input voltage range and is designed for a wide range of applications. Ultra-w...[Details]
-
With the rise of digital streaming, traditional physical media such as vinyl and CDs are gradually fading from people's horizons. However, with the support of a group of retro enthusiasts, some manuf...[Details]
-
CS5350/CS5328 Solar panel powered lead-acid battery, lithium iron phosphate battery, lithium battery charging management IC series
In 2021, the time-sharing power restrictions across...[Details]
-
Features: STM8S003F3P6 uses a single bus to establish simple communication with DS18B20, DS18B20 feedbacks the temperature value, the digital tube displays the temperature value without decimals, and...[Details]
-
0 Introduction
Due to the imaging mechanism of infrared images and the reasons of infrared imaging itself, infrared images have the characteristics of low contrast, blurred images, and hig...[Details]
-
Reactive cone made of new reactive textile. Photo credit: Pedro Silva/Aalto University According to a paper published in the latest issue of the journal Advanced Materials, researchers from Aalto ...[Details]
-
The STM32F10xxx supports three reset modes: system reset, power-on reset and backup area reset. 1. System reset A system reset resets all registers to their reset states, except for the reset flag i...[Details]
-
Technical inspection of DC to
AC inverters Structural requirements for pure sine wave inverters:
1. All fasteners of the inverter should have anti-corrosion plating or coating, and the fast...[Details]
-
After reading the nine levels of analog circuit design from section one to section nine, you will know your level.
One section
You have just started to enter this industry, and you on...[Details]
-
Recently, Zhejiang Jinmate Group Co., Ltd. (hereinafter referred to as "Jinmate"), a smart manufacturing solution service provider, completed a round B financing of over 400 million yuan.
...[Details]
-
CAN is the abbreviation of Controller Area Network (CAN). It was developed by BOSCH, a German company famous for the research and development and production of automotive electronic products, and e...[Details]