1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3. Phase noise degrades with increasing output frequency.
4. Subject to technical modi cation.
5. Contact factory for availability.
For Additional Information, Please Contact
USA:
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
Europe:
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 3328.4784.17
Fax: +49 (0) 3328.4784.30
Asia:
Vectron International
1F-2F, No 8 Workshop, No 308 Fenju Road
WaiGaoQiao Free Trade Zone
Pudong, Shanghai, China 200131
Tel: 86.21.5048.0777
Fax: 86.21.5048.1881
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
[size=4]The source code of the microcontroller is as follows:[/size] [size=4]/**[/size] [size=4]******************************************************************************[/size] [size=4]* @file FD...
Introduction to AND Gate Circuits From small electronic watches to complex electronic computers, many of their components are made into integrated circuits, that is, dozens, hundreds, or even tens of...
This content is originally created by EEWORLD forum user hpq916 . If you want to reprint or use it for commercial purposes, you must obtain the author's consent and indicate the source....
Repairing an imported ventilator, the pressure detection and rate output amplifier circuits are like this. There are three types of operational amplifiers: two of which are not commonly used, LT1079 a...
Please advise, how to choose the appropriate capacitor withstand voltage value based on EMC test such as CI, ESD, etc.?Previously, I thought the highest test voltage was 34V, so I chose 50V withstand ...