RSB6RM17130411

Program requirements: Through the timer interrupt configuration, interrupt once every 500ms, and then control the LED in the interrupt service function to achieve LED1 state inversion Here are the ...[Details]

Before using the reduction motor, the installation shaft should be cleaned and checked for collision and dirt. If there is any, all of them should be removed. Check whether the matching size of the...[Details]

A Yantai-based manufacturer of precision temperature-measuring infrared thermal imaging cameras drew up a list of bottleneck materials and requested 11 suppliers across the country to resume work. As...[Details]

1. Introduction to digital tube scanning This experiment is an extension of the GPIO output function. It uses GPIO to drive the digital tube to perform dynamic scanning to achieve the purpose of disp...[Details]

    Abstract: The structure, principle, and function of the digital quadrature upconverter AD9857 are introduced, and its specific application in the transmission channel of high-frequency radar sys...[Details]

The current cold cathode fluorescent tube technology is very mature, and its life span is 30,000 to 50,000 hours, but cold cathode fluorescent tubes also have many disadvantages. First of all, the ...[Details]

1 Introduction Since frequency signals have the advantages of strong anti-interference, easy transmission, and high measurement accuracy, many non-frequency sensor signals are converted into f...[Details]

Since the previous version of iOS 14.5.1 had an iPhone slowdown issue, the new version has fixed this, and both the startup speed and GeekBench 5 running scores are back to normal. However, the versi...[Details]

      Today, Chen Jin, general manager of Lenovo Group’s mobile phone business unit in China, shared a comparative review of Xiaomi 12 and Motorola edge X30 on Weibo. 　　Chen Jin said that looking at ...[Details]

Use structures to manipulate registers: //When assigning and retrieving register values, pay attention to the length of the register. Some register values ​​are only 8 bits. //Also note, use volati...[Details]

The purpose of my program is to enable the timer to update the interrupt, implement a 1S interrupt for the timer, and then flip the LED level once in the interrupt function. 1. First, turn on the c...[Details]

Fujian Energy Supervision Office, Fujian Development and Reform Commission, and Fujian Industry and Information Technology Department jointly issued the notice of "Fujian Electricity Market Medium-...[Details]

The Keithley 6430 electrometer features ultra-low noise 0.4fA pp and preamplifier and is widely used for low-level signal measurements such as studying single electron devices, high resistance nanowi...[Details]

On September 27, the Ministry of Industry and Information Technology released the list of national technology innovation demonstration enterprises in 2019. Among them, Internet technology companies B...[Details]

introduction 　　Proper PCB layout is critical, especially in the design of high-frequency switching regulators (such as the MAX20021/MAX20022). An optimized PCB layout can provide clean outputs and ...[Details]