[color=#555555][font="][size=14px]The serial port UART of DSP 5502 uses DMA to transfer data, 16 bytes at a time, and any bytes exceeding 16 bytes will be lost. Is there something wrong with my config...
bq76930 error in reading temperature value
Most of the time, the current, voltage and temperature are normal, but from time to time the temperature will be read as very high, higher than 100 degrees, ...
Hardware: MCU: MSP430F149Crystal: 32K, 8MInput signal: 10ms low level, 7.5ms high level received via wireless,Input port: P4.0 (TB0)Requirement: Capture the pulse width of the low level
Software:1. In...
I used CPLD to make an AES/EBU audio decoder. I used a 50MHZ crystal oscillator as a counter to count. I decoded the data stream based on the counter size. I used a sine wave as the source. The peak-t...
This section attempts to describe the structure of P2G hardware and software at a certain level.
Regarding the hardware composition and a rough introduction of Position2Go, the official provides two A...