Figure 7. Standard PECL Output Configuration Figure 8. Single Resistor Termination Scheme
Resistor values are typically 140 ohms for
3.3V operation.
Resistor values are typically 84 ohms for 2.5V
operation.
The VCC6 incorporates a standard PECL output scheme, which are un-terminated emitters as shown in Figure 7. There are numerous application notes on
terminating and interfacing PECL logic and the two most common methods are a single resistor to ground, Figure 8, and a pull-up/pull-down scheme as
shown in Figure 9. An AC coupling capacitor is optional, depending on the application and the input logic requirements of the next stage.
LVDS Application Diagrams
V
CC
LVDS
Driver
100
LVDS
Receiver
LVDS
Driver
100
Receiver
OUT+
OUT-
Figure 10 Standard LVDS
Output Configuration
Figure 11. LVDS to LVDS Connection, Internal 100ohm
Figure 12. LVDS to LVDS Connection
Some LVDS structures have an internal 100 ohm resistor on the
External 100ohm and AC blocking caps
input and do not need additional components.
Some input structures may not have an internal 100 ohm
resistor on the input and will need an external 100ohm
resistor for impedance matching. Also, the input may have
an internal DC bias which may not be compatible with
LVDS levels, AC blocking capacitors can be used.
One of the most important considerations is terminating the Output and Complementary Outputs equally. An unused output should not be left un-termi-
nated, and if one of the two outputs is left open it will result in excessive jitter on both. PC board layout must take this and 50 ohm impedance matching
into account. Load matching and power supply noise are the main contributors to jitter related problems.
When it comes to the Internet of Things, many students can also point out some characteristics and list some examples of their own applications. With the development of network technology and the adve...
Functions like HAL_I2C_Master_Transmit and HAL_I2C_Mem_Write send start, data, and stop signals as a set.
Because I want to read a temperature sensor, this sensor needs a delay after the second start ...
Software platform: MounRiver Studio (MRS), hardware platform: CH32V103 development board, and an SD card less than 32G.
1. Introduction to SD Card
SD memory card (Secure Digital Memory Card) is a new ...
1. First, here is a big picture. The whole picture of the board.2. The user manual of the board and the data sheet of the main chip.3. Pay attention.a. The supply voltage range of the board is 5~26V.b...
The Spring Festival is almost over today. Even though I had a long Spring Festival, I will go back to Guangzhou tomorrow. Tonight, I put aside all my struggles for fame and fortune and decided to cont...
MicroPython Open Source section
京公网安备 11010802033920号
EEWORLD
