It is very convenient to use Arduion to program STM32. Currently, it can support many ST official boards, as shown in the figure below. However, when downloading, there is basically no speed. I think ...
[align=center][/align] [align=center][align=left]On September 12, at the popular STMicroelectronics conference held in Beijing, engineers from Airlabi gave a wonderful presentation to engineers at the...
TI's UCC28780 is a high-frequency active clamp flyback controller with fully and partially zero-voltage switching (ZVS) primary FETs with adaptive control, programmable timing for external Si or GaN F...
As shown in the figure, what is the role and principle of adding a ground via hole near the via hole of the routing? The vias of the PCB board can be classified into the following types according to t...
I want to debug the LIS25BA sensor. I don't have a level conversion chip, so I want to change the NUCLEO to 1.8V power supply.
For debugging convenience, I first changed the 3.3V LDO of ST-LINK to 1.8...