HLMA-PJ00-TWK14 datasheet, PDF

Datasheet> All Categories > LED optoelectronic/LED> photoelectric> HLMA-PJ00-TWK14

HLMA-PJ00-TWK14: DescriptionSINGLE COLOR LED, ORANGE, 1.525mm, PLASTIC PACKAGE-2; CategoryLED optoelectronic/LED photoelectric; File Size71KB，9 Pages; ManufacturerAVAGO; Websitehttp://www.avagotech.com/

Download Datasheet Parametric View All

HLMA-PJ00-TWK14 Overview

SINGLE COLOR LED, ORANGE, 1.525mm, PLASTIC PACKAGE-2

HLMA-PJ00-TWK14 Parametric

Parameter Name	Attribute value
package instruction	PLASTIC PACKAGE-2
Reach Compliance Code	unknown
Is Samacsys	N
color	ORANGE
Configuration	SINGLE
Maximum forward current	0.05 A
Lens type	UNTINTED NONDIFFUSED
Nominal luminous intensity	1125.0 mcd
Installation features	SURFACE MOUNT
Number of functions	1
Number of terminals	2
Maximum operating temperature	100 °C
Minimum operating temperature	-40 °C
Optoelectronic device types	SINGLE COLOR LED
total height	2.16 mm
method of packing	TAPE AND REEL 13"
peak wavelength	605 nm
shape	ROUND
size	1.525 mm
surface mount	YES
perspective	125 deg
Base Number Matches	1

Preview

Download Datasheet

View All

HLMA-Qx00, HLMA-Px00 HLMT-Px00 and HLMT-Qx00

Subminiature High Performance AlInGaP LED Lamps

Data Sheet

SunPower Series

HLMA-PF00, HLMA-PG00, HLMA-PH00, HLMA-PL00, HLMA-QF00, HLMA-QG00, HLMA-QH00,

HLMA-QL00, HLMT-PG00, HLMT-PH00, HLMT-PL00, HLMT-QG00, HLMT-QH00, HLMT-QL00

Description

Flat Top Package

The HLMX-PXXX flat top lamps use an untinted, nondif-

fused, truncated lens to provide a wide radiation pattern

that is necessary for use in backlighting applications. The

flat top lamps are also ideal for use as emitters in light

pipe applications.

Features



Subminiature flat top package

Ideal for backlighting and light piping applications



Subminiature dome package

Nondiffused dome for high brightness



Wide range of drive currents



Colors: 590 nm Amber, 605 nm Orange, 615 nm Red-

dish-Orange, 622/626 nm Red, and 635 nm Red



Ideal for space limited applications



Axial leads



Available with lead configurations for surface mount

and through hole PC board mounting

Dome Packages

The HLMX-QXXX dome lamps use an untinted, nondif-

fused lens to provide a high luminous intensity within a

narrow radiation pattern.

Lead Configurations

All of these devices are made by encapsulating LED chips

on axial lead frames to form molded epoxy submini-

ature lamp packages. A variety of package configuration

options is available. These include special surface mount

lead configurations, gull wing, yoke lead, or Z-bend. Right

angle lead bends at 2.54 mm (0.100 inch) and 5.08 mm

(0.200 inch) center spacing are available for through hole

mounting. For more information refer to Standard SMT

and Through Hole Lead Bend Options for Subminiature

LED Lamps data sheet.

Technology

These subminiature solid state lamps utilize one of the

two newly developed aluminum indium gallium phos-

phide (AlInGaP) LED technologies. The HLMT-Devices

are especially effective in very bright ambient lighting

conditions. The colors 590 nm amber, 605 nm orange,

615 nm reddish-orange, 622/626 nm red, and 635 nm red

are available with viewing angles of 15° for the domed

devices and 125° for the flat top devices.

Recommended Resources

On and off states generate fixed-width pulse circuit

Power line carrier remote alarm circuit diagram

Infrared transmitter circuit using quartz crystal oscillator

Using LM1812 for wide range ultrasonic ranging circuit

Standard boost application circuit diagram

Four and a half digit LED counting circuit

About the IP address routing of the WiFi module: What is the IP address of the WiFi module? IP is the abbreviation of Internet Protocol, which means "protocol for interconnection between networks", that is, a protocol designed for computer networks ...; Jacktang RF/Wirelessly

DSP TMS320F28335 interrupt vector table: Since the addresses corresponding to each interrupt source of F28335 are set in advance and cannot be changed, we must prepare an interrupt vector table.It can be seen from the figureINT1-INT12 each c...; fish001 DSP and ARM Processors

(3) UART DMA plus IDLE interrupt indefinite length byte reception: The amount of data received by radar applications is relatively large, so DMA is needed to increase the speed and reduce the MCU load. The previous project has used DMA+IDLE interrupt on the STM32F103...; lbbook GD32 MCU

This positioning hole and via are the same as repairing a building.: 3D display adjustment viewThis content is originally created by EEWORLD forum user btty038 . If you want to reprint or use it for commercial purposes, you must obtain the author's consent and indicate...; btty038 PCB Design

SVPWM control of sensored BLDC cannot start when fixed sector 5: STM32F103 chip is used, and the two-way motor driver board is used.It is pure SVPWM control, not FOC. The phase is judged by the sensed HALL.The first motor is driven by TIM1, started, and the speed c...; pingis58 Motor Drive Control（Motor Control）

TMS570 Learning 1- Creating Engineering Lighting: [i=s]This post was last edited by Shi Yu on 2019-8-16 14:57[/i]Software environment: Operating system: Windows 10 IDE：CCS7.4 Code generation tool: HALCoGen 04.07.01 Hardware environment: Target board:...; 石玉 Microcontroller MCU

Shortcut: E0 E1 E2 E3 E4 E5 E6 E7 E8 E9 EA EB EC ED EE EF EG EH EI EJ EK EL EM EN EO EP EQ ER ES ET EU EV EW EX EY EZ F0 F1 F2 F3 F4 F5 F6 F7 F8 F9 FA FB FC FD FE FF FG FH FI FJ FK FL FM FN FO FP FQ FR FS FT FU FV FW FX FY FZ G0 G1 G2 G3 G4 G5 G6 G7 G8 G9 GA GB GC GD GE GF GG GH GI GJ GK GL GM GN GO GP GQ GR GS GT GU GV GW GX GZ H0 H1 H2 H3 H4 H5 H6 H7 H8 HA HB HC HD HE HF HG HH HI HJ HK HL HM HN HO HP HQ HR HS HT HU HV HW HX HY HZ I1 I2 I3 I4 I5 I6 I7 IA IB IC ID IE IF IG IH II IK IL IM IN IO IP IQ IR IS IT IU IV IW IX J0 J1 J2 J6 J7 JA JB JC JD JE JF JG JH JJ JK JL JM JN JP JQ JR JS JT JV JW JX JZ K0 K1 K2 K3 K4 K5 K6 K7 K8 K9 KA KB KC KD KE KF KG KH KI KJ KK KL KM KN KO KP KQ KR KS KT KU KV KW KX KY KZ

Popular Components