GSP2.351C.24

Gloss tester is a testing tool, which is used to measure the surface gloss of ceramics, paint, ink, plastic, marble, hardware and other materials. Gloss tester has a wide range of applications, includ...[Details]

Since 2010, developed countries such as Europe, the United States, and Japan have begun to implement laws to ban incandescent bulbs. The reason for the laws is to restrict light sources with low ...[Details]

Programming the movement condition FB ONL (only if): Movement conditions are used to be able to stop the robot in a targeted manner, for example in the event of a fault or in the event of a lo...[Details]

1. Light up the conjecture at the same time In the first section of this chapter, we said that if we want to light up the digital tube, then the small LED light we learned in the first chapter will...[Details]

The penetration rate of 3D sensing in high-end smartphones is gradually increasing, and 5G is driving other emerging applications, which is expected to boost the output value of VCSEL. According to T...[Details]

Communication experiment between ATMEGA16 and PC 1 //The PC sends a character to the microcontroller. After receiving it, the microcontroller displays it on the LED and sends it back to the PC //The ...[Details]

1 Briefly, modbus is a master-slave communication protocol between multiple industrial devices. As long as the two devices are in a master-slave relationship using the modbus protocol and are connecte...[Details]

Fast SPI ports enable bit-bashing through GPIO pins and serve as a low-cost alternative to 8051-compatible microcontrollers with SPI ports. The code shown in this application note takes advantage of ...[Details]

To reset the C51MCU, a high level needs to be connected to the 9th pin for 2us (two clock cycles). The MCU system is reset once when it is powered on, and the system is reset again when the key is pr...[Details]

In the process of industrial control, it is necessary to collect real-time data of the controlled object, and according to the actual situation of the collected data, it is necessary to monitor it in...[Details]

Project Overview: 　　Introduction 　　Since the concept of virtual instrument was proposed, the automatic test system built by replacing hardware with software, code with graphics, programming with confi...[Details]

Self-driving cars, also known as driverless cars, computer-driven cars, or wheeled mobile robots, are intelligent cars that are unmanned by computer systems. They have been around for decades in the ...[Details]

In real life, many people forget to bring something when they go out, such as keys, wallets, etc. Nowadays, mobile payment is so convenient that it is normal to forget to bring wallets, but keys must...[Details]

After years of technological development, fuel cells have been on the road to mass production since 2015. The previously troublesome establishment of hydrogen supply infrastructure has also seen ho...[Details]

1. Comparison of I2S, AC97, PCM between S3C6410 and WM9713: 1. I2S, AC97, and PCM are different, each has its own, and the timing of the three is different. For the two sides to communicate, t...[Details]