Magnetic Proximity Sensors (Hall Effect)
MP1013 Sensors
Hall-effect position sensor with convenient snap-fit mounting
Description
The MP1 Series sensors are one-piece non-contact solid-state position sensors. The sensors operate through the use of Hall Effect
technology with magnetic fields generated by permanent magnets. They provide a sinking current output.
Features
•
•
•
•
•
•
•
•
•
Solid state reliability
Stable output over operating temperature range
Open collector (NPN) output can be used with bipolar or CMOS
logic circuits with suitable pull-up resistor
South pole sensitive
Unipolar device (MP101301, MP101302)
Latching version available (MP101303)
RoHS compliant
Fastener-less design
IP67
Typical Applications
•
•
•
•
•
Door position & interlock
Limit switch
Flow/speed
Home security
Pedal switch
Environmental Specifications
Operating / Storage Temperature (MP101301, MP101303)
Operating / Storage Temperature (MP101302)
Ingress Protection
-40 °C to 85
⁰C
(-40
⁰F
to 185
⁰F)
-40
⁰C
to 125 °C (-40
⁰F
to 257
⁰F)
IP67
Electrical Specifications
Operating Supply Voltage
Supply Current (MP101301, MP101302)
Supply Current (MP101303)
Output Current (Sink) (MP101301, MP101302)
Output Current (Sink) (MP101303)
Maximum Input Voltage (MP101301, MP101302)
Maximum Input Voltage (MP101303)
Maximum Reverse Voltage (MP101301, MP101302)
Maximum Reverse Voltage (MP101303)
Recommended Pull-Up Resistor
5 to 24 VDC
4.1 mA typ., 7.5 mA max.
2.6 mA typ., 5 mA max.
25 mA max.
20 mA max.
30 VDC
28 VDC
30 VDC
None
See chart
Mechanical Specifications
Housing Material
Glass-reinforced nylon plastic
Turn on / off (MP101301, MP101302)
245 Gauss / 60 Gauss
Turn on / off (MP101303)*
60 Gauss / 60 Gauss
*MP101303 is a latching sensor and releases when 60 Gauss is applied to the north pole
www.cherryswitches.com
Page 1 of 2, Last update 2016-01-05, Specifications subject to change without notice.
Products
Part Number
MP101301
MP101302*
MP101303*
*Not commonly stocked
Leads
24 AWG x 150 mm
24 AWG x 150 mm
24 AWG x 150 mm
Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be connected
between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable.
Recommended External Pull-Up Resistor
Volts DC
Ohms
5
1k
9
1.8k
12
2.4k
15
3k
24
3k
Open Collector Sinking Block Diagram
Dimensions mm (inches)
www.cherryswitches.com
Page 2 of 2, Last update 2016-01-05, Specifications subject to change without notice.
京公网安备 11010802033920号
EEWORLD
