ROB-12460

Why does the motor use a rectifier bridge? The main purpose of using a rectifier bridge in a motor is to convert AC power into DC power so that it can drive the motor efficiently. ...[Details]

1. Vector Control FOC Vector control (FOC, Field Oriented Control) decomposes the stator current into excitation component and torque component under the premise of rotor magnetic field orient...[Details]

In daily power supply design, engineers often face the problem of insufficient control IC drive current or excessive control IC power consumption due to gate drive loss. To alleviate this problem, en...[Details]

NiCd battery discharger The biggest disadvantage of nickel-cadmium batteries is the memory effect. An effective way to eliminate the memory effect is to fully discharge t...[Details]

High-performance computing and artificial intelligence are forming two wings that promote the rapid development of the semiconductor industry. Faced with the challenge of Moore's Law approaching the...[Details]

Today, blogger @熊猫很禿然 exposed the renderings of iQOO Neo6. The leaked picture shows that iQOO Neo6 uses a center-hole OLED straight screen. The number "13" in the picture suggests that iQOO Neo6 may ...[Details]

At present, more and more application systems have put forward higher requirements on the power density and conversion efficiency of power supply systems. In the design of power supply systems, power...[Details]

Introduction to the connection method of RJ45 network interface twisted pair cable The maximum transmission distance of twisted pair is 100 meters; there are two connection methods: EIA/TI...[Details]

CISC (Complex Instruction Set Computer) and RISC (Reduced Instruction Set Computer) are two architectures of current CPUs. The difference between them lies in different CPU design concepts and method...[Details]

#include reg51.h sbit out = P0^0; void Init_Timer0() { TMOD=0x10; TH0=256-1; TL0=256-1; EA=1; ET0=1; TR0=1; } void T0_ISR() interrupt 1 { static unsigned int i; i++; if (i==1) { out = ~out; } if ...[Details]

　　The dynamic balancing tester is conveniently used for measuring the dynamic balance, correcting the dynamic balance and analyzing the signals of rotating machinery such as steam turbines, water turb...[Details]

Advantech Launches iBMC Out-of-Band Management Solution to Reduce System Downtime for Remote Management at the IoT Edge In May 2021, Advantech launched its out-of-band management sol...[Details]

Network Analyzer Block Diagram Figure 1 shows the internal block diagram of a network analyzer. To complete the transmission/reflection characteristic test of the device under test, the network analy...[Details]

According to the data, the prototype of the stepper motor appeared as early as around 1870. After the advancement of permanent magnet manufacturing technology in the 1960s, it developed rapidly and...[Details]

November 14, 2024 – Mouser Electronics, the industry’s leading New Product Introduction (NPI) distributor of the broadest selection of semiconductors and electronic components™, is now offering...[Details]