The following uses the design of a street light controller as an example to illustrate how to use ADC12. Street lights will go out above a certain brightness value, and light up when the brightness is...
[align=center][color=rgb(34, 34, 34)][font="][size=14px] [b][color=#5E7384]This content is originally created by [size=3]无限龙神[/size], a user of EEWORLD forum. If you need to reprint or use it for comm...
Target board: C2000 28335/28069
I. Main ideas:1. Prepare an upgrade program (equivalent to a bootloader) as the first program to run when powered on. Enter the upgrade program, first determine whether...
1) The size of the pads of the patch layer and the circuit layer is consistent with the size of the pads of the bare copper of the physical PCB. This is the basis for the size of the opening (a necess...
The signal generator outputs two 10KHZ sine wave signals at the same time, which are added to the channel 0 and channel 2 of the single-chip microcomputer (MCU uses STM32F030C8T6) and collected altern...
I have used F4 FMC to drive LCD before, and thought it would be a piece of cake to move it to H7. However, after working on it for several days, I still couldn't get any signal, and the Hal library, L...