The following figure shows a buck-boost circuit generated using TI WEBENCH. The main control IC is LM5118.The parameters are as followsInput voltage range: DC22.0V-DC45V;Output voltage: DC24.0V;Contin...
Dear experts, it is said that when the positive and negative inputs of an op amp are equal, the output is 0. Does this 0 refer to the middle point of the positive and negative power supplies, or the a...
[i=s]This post was last edited by Aguilera on 2018-6-13 22:21[/i] [size=5] The MSP430 has the ability to program any single bit, byte, or word anywhere in the flash memory, in-system. The flash memory...
Radio waves need to be transmitted, and the frequency must be high enough, such as 900MHZ and 1800MHZ of GSM. The frequency of sound is very low, only 20HZ-20KHZ. This frequency signal cannot be trans...
[font=微软雅黑][size=4]Event: [url=https://en.eeworld.com/bbs/elecplay/content/105] Try TouchGFX with prizes and start your creative GUI journey[/url] Many netizens have previously reported to us that the...