1. The third experimentLast two times we did two experiments, both of which used the P1.0 pin to turn on the light. We can imagine: since P1.0 can turn on the light, can other pins do the same? Take a...
[i=s]This post was last edited by fish001 on 2018-9-25 14:55[/i] [size=4] Usually, we often mention the three parameters of temperature sensors, such as resolution, sensitivity and accuracy. But many ...
I got a STM32L151C8T6 board, powered by a 3.3V button battery. But the battery died. I used STLINK to power it, and it should be 3.3V, but when I measured it with a multimeter, it was 4.77V, and somet...
Here is a flashing light experiment procedure for everyone As shown in the figure below: Connect a light-emitting diode L1 to the P1.0 port , so that L1 is constantly on and off. 2.Circuit diagram Fig...