The intensity obtained by the X-NUCLEO-IKA01A3 magnetic sensor has three values: x, y, and z. After testing, the change direction mainly affects the data x and y, while the data z has little effect. I...
The normal operating voltage VCC of the circuit is 24V, the current is 1A, the maximum operating voltage Vmax is 26V, and the maximum transient voltage that the subsequent circuit can withstand is 50V...
Half-bridge drivers (also called high-side/low-side drivers) reduce switching losses, adapt to noisy environments, and improve system efficiency.Fundamentals of MOSFET and IGBT gate driver circuits
Re...
Original author: KVIN Reprinted from here
For motor control, complementary PWM is often used. If FOC is used, center-aligned mode (center-aligned mode) is also used. The following is a discussion of c...
I am going to let the microcontroller communicate via radio frequency, and I bought two E10-433MD radio frequency modules from Chengdu Yibite. The modules use the SI4463 chip. I have been looking for ...
[b]Purpose[/b] Compare the test accuracy of several ultrasonic sensors to provide a reference for everyone's use. [b]Methods[/b] Write different programs into microbit, use McQueen's ultrasonic sensor...