For free samples & the latest literature: http://www.maxim-ic.com, or phone 1-800-998-8800
CMOS High-Speed 8-Bit ADCs with
Multiplexer and Reference
MAX154/MAX158
ABSOLUTE MAXIMUM RATINGS
Supply Voltage, V
DD
to GND.........................................0V, +10V
Voltage at Any Other Pins........................GND -0.3V, V
DD
+0.3V
Output Current (REF OUT)..................................................30mA
Power Dissipation (any package) to +75°C ....................450mW
Derate above +25°C by ..............................................6mW/°C
Operating Temperature Ranges
MAX15_ _C_ _.....................................................0°C to +70°C
MAX15_ _E_ _ ..................................................-40°C to +85°C
MAX15_ _M_ _ ...............................................-55°C to +125°C
Storage Temperature Range .............................-65°C to +160°C
Lead Temperature (soldering, 10sec) .............................+300°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
This article and design code were written by FPGA enthusiast Xiao Meige. Without the author's permission, this article is only allowed to be copied and reproduced on online forums, and the original au...
I bought a device, which is a full-body conference microphone. After connecting to the video conferencing software, it acts as a microphone and an audio output device.
When connected to the computer v...
Program function: Configure GPIO12 as interrupt input. When the button is pressed, a falling edge interrupt is triggered, and the interrupt service subroutine flips the LED.
Interrupt vector tableMain...
[color=rgb(51, 51, 51)][font="][size=14px]SN-D2 is a power tube gate driver IC designed for bridge circuits using dual N-channel VDMOS power tubes. It can be used in DC brushed, DC brushless motors an...
Currently, there are three main types of light sources for car headlights on the market: halogen, xenon and LED headlights. Halogen headlights are the main element of car light fillers, and the main e...
(I) Measuring resistance with a multimeter The ohmmeter of a multimeter can measure the resistance of a conductor. The ohmmeter is represented by "Ω" and is divided into four ranges: R×1, R×10, R×...[Details]
This afternoon, Xiaomi released two 5G mobile phones, Xiaomi 9 Pro and Xiaomi MIX Alpha. The lowest price of Xiaomi 9 Pro is 3,699 yuan, which is the lowest price of 5G mobile phones released so far....[Details]
Hello everyone, ZHIYUAN Electronics takes users' interests into consideration and provides you with the CSV data file export function of signal waveform, FFT analysis and many standard protocol analy...[Details]
1. Applicability: Property professionals should conduct on-site identification and assessment of harmful gases in the limited space where the family is located to determine whether the sensors of...[Details]
STM32F103ZET6 has 7 groups of IO, each group has 16 IO ports, 16×7=112, from GPIOA-GPIOG IO port identification with FT means that the IO port can be connected to 5V high level. All IO ports can be...[Details]
0 Preface
The advantages of the MAC protocol based on CSMA/CA are its simplicity and robustness. It is suitable for distributed networks. Each node does not need to maintain and dynamically update t...[Details]
Mouser Electronics Adds 110 New Manufacturer Partners in 2021, Further Improving Its Product Distribution Lineup January 18, 2022 – Mouser Electronics, the leading distributor of electronic compone...[Details]
ATMEGA16A uses Toshiba LB1847 chip to drive stepper motor Toshiba LB1847 pin diagram: LB1847 Typical Application Circuit Diagram ton : Output ON time toff : Output OFF time tm :...[Details]
At present, there are two main ways to transfer the images captured by the camera to the computer for playback and processing: one is through the image acquisition card; the other is to use the USB in...[Details]
When we use microcontrollers, precise delay is often required. For example, when communicating with DS18B20, strict timing must be followed, which requires us to strictly control the execution time o...[Details]
The high-frequency pulse current transformer is a one-meter passive non-contact current probe designed for testing rapidly changing AC currents, including transient currents, harmonic currents, hig...[Details]
Recently, a new iQOO phone with model number "V1936AL" appeared on the website of the Ministry of Industry and Information Technology. This new phone also appears in the Android Enterprise list...[Details]
Welding is a technique or process that uses automation to perform welding tasks, while a common welder is a device usually operated by humans and used to fuse two or more metal and non-metal parts ...[Details]
On October 15, the reporter learned that the installation and commissioning of the LDK 42KWp solar carport has been completed and successfully connected to the grid for power generation. This is c...[Details]
This application note provides design guidelines for the optomechanical part of the MAX25205 and MAX25405 gesture sensors. A key design issue in gesture detection systems based on infrared (IR) tec...[Details]
ARM Technology
京公网安备 11010802033920号
EEWORLD
