Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
Recommended content:
1. Recommended by domestic ARM manufacturers: GigaDevice
The entire STM32 series has corresponding substitutes, which can be replaced in situ. Its 103, 407 and other series have b...
Event details: [Anxinke NB-IoT development board EC-01F-Kit]Updated to 2021-12-11Evaluation report summary:@kit7828[Anxinke NB-IoT Development Board EC-01F-Kit] 1. Unboxing and Hardware Appreciation@秦...
Event has ended
Due to the impact of the epidemic, the list of winners will be announced later.
Once the list of winners is confirmed, we will immediately notify the winning netizens to claim their pr...
[align=left]Section 2 Charge and Discharge Management[/align] [align=left]Under normal circumstances, VBAT will charge the backup battery while supplying power to the load; when encountering an emerge...
Note: Dual color temperature dimming is mainly achieved by changing the capacitance of C1 and C2, which results in different delays in VDD power-on time. Multiple capacitors are increased in sequence ...
introduction
An isolated converter is needed to provide electrical isolation between two related systems. In certain applications, isolation between the power supply and the load is required t...[Details]
ATPCS recommends that the number of formal parameters of a function should not exceed 4. If the number of formal parameters is less than or equal to 4, the formal parameters are passed through the fo...[Details]
The compiler can use the keyword const to define constants in flash. For example, keil, ICC, etc. define constants using const unsigned char data=0; then the type of data is a constant stored in flas...[Details]
The road to smart driving
chips
is not easy. Let’s review Horizon Robotics and Black Sesame together over the weekend.
● Horizon Robotics has completed 15 rounds of financing...[Details]
When the manufacturer configures the battery, the design capacity selected is to fully meet or even exceed the power capacity and power supply time requirements of the load without power outage. Ho...[Details]
1. What is Proteus 8 Professional? Proteus is an EDA tool software launched by Lab Center Electronics. Proteus has the features of schematic layout, PCB automatic or manual wiring, SPICE circuit si...[Details]
Torque motor features
The characteristics of torque motors are that they have soft mechanical characteristics and can be stalled. When the load torque increases, the speed can be automatically...[Details]
The leakage problem of solar panels can traditionally be solved by using a Schottky diode in series with the solar panel, but the forward voltage drop of the Schottky diode causes it to consume ...[Details]
One network cable, one IP, and all operations are done by IE browser. Whether it is viewing waveforms, taking screenshots, or upgrading firmware, it's all done, it's that simple! 1. Operation s...[Details]
When the topic of next-generation console resolutions comes up, we hear a lot about 4K, but what about 1440p? Obviously, the Xbox Series S supports 1440p as it is designed specifically for that res...[Details]
On May 23, General Motors announced a new generation of automotive electronic architecture on Monday. This electronic architecture is built on ultra-high-speed Ethernet and can process information ...[Details]
With the new K58 option for its oscilloscopes R&S RTO and R&S RTP, Rohde & Schwarz has launched the world's first trigger and decode solution for 1000BASE-T1, further extending its leadership in auto...[Details]
At the Huawei P30 series new product launch conference, photography technology was undoubtedly the focus of the focus. In addition to the first launch of a 10x lossless optical variable production mo...[Details]
As we all know, embedded development is a low-level development, and the main programming languages are C and assembly. So the source files to be discussed in this article mainly refer to C files...[Details]
The rapid development of microelectronics and software technology is profoundly changing the design of in-vehicle entertainment control and safety systems, redefining the driving experience.
...[Details]