[i=s]This post was last edited by flyriz on 2020-4-23 19:58[/i]Hello everyone, as shown below:An AC input signal is input to the input end of a voltage follower circuit and an amplifier circuit. The p...
The DCDC circuit design in the figure below has an input of 20-36V and is required to output 19.5V. When the current reaches more than 350mA, the voltage drops to about 10V.
The input power supply is ...
[i=s]This post was last edited by Rambo on 2018-8-13 16:54[/i] [font=微软雅黑][size=5]There are official and third-party ones. Very complete. In response to the requests of netizens, several compressed pa...
1. AT+CGMI gives the module manufacturer's identification.2. AT+CGMM gets the module identification. This command is used to get the supported frequency bands (GSM 900, DCS 1800 or PCS 1900). Whenthe ...
[size=4] The first step to implement the HPI boot mode of TMS320C62x is to generate the HPI boot DSP code and merge it with the main processor application so that the DSP application can be remotely d...
The serial port receiving and sending program of MSP430 microcontroller involves multiple registers, which can be configured step by step according to the following steps:1. First, set the used IO por...