[i=s]This post was last edited by zhangyadong300 on 2018-10-19 22:10[/i] I had a solar panel and wanted to make a smart charger. The microcontrollers I had were not suitable. I signed up for the event...
Now there are two outputs 12V / 5V. Because of power limitation, the output current must be limited. When the output current is too large, the current limiting IC must have an output (such as an exter...
[font=Tahoma][size=3]The LTC6811 chip launched by Lingte before can only monitor 12 single-cell lithium batteries, but the current LTC6813 can finally monitor 18. In order to design BMS faster and wit...
[i=s]This post was last edited by piaoroumi on 2018-11-2 11:26[/i] Read WHO_AM_I and get 69, configure accelerometer: gYroscopeWrite(CTRL9_XL, 0x38);//XL configure gYroscopeWrite(CTRL1_XL, 0x60);//XL ...
Load switch controls battery voltage output more reliably and simply than MOS.Load switch should be different from analog switch, right? However, the control logic is the same, and the circuit structu...
Why is embedded microprocessor architecture design so complicated : https://training.eeworld.com.cn/course/6146Why is embedded microprocessor architecture design so complicated?...