2-A-06-048.0-06-H-2

Example 1: The line scan flyback switching transformer used in televisions is referred to as a high-voltage package. Its working principle also belongs to the flyback switching transformer. The induc...[Details]

Use 358 to make an adder, through ADC0831 AD conversion, 51 single-chip microcomputer control, it can measure the voltage value from positive 2.5V to negative 2.5V. It can be expanded to measure larg...[Details]

1 Introduction With the development of electronic and computer technology, video surveillance systems are developing from analog technology to digital technology. From the perspective of h...[Details]

An ammeter, also called an ammeter, is used to measure the current in a circuit. The ammeter has three terminals and two ranges; the two ranges share a "+" or "-" terminal, marked "0.6" and "3" is a ...[Details]

On December 12, Shanghai Analog Semiconductor Technology Co., Ltd., a high-quality analog and mixed-signal chip design company, has completed a nearly 200 million yuan Series A financing. This round ...[Details]

On September 6, according to the official account of Wingtech Technology, on September 4, Nexperia Semiconductor (China) Co., Ltd., a wholly-owned subsidiary of Wingtech Technology, held a SiP produc...[Details]

The ADALM1000 is essentially a signal source measurement unit, but it can also be viewed as a standalone oscilloscope and function generator. However, when viewed separately, since the output functio...[Details]

There were many difficulties in configuring Qt for ARM platform, especially adding phonon support, which was even more troublesome. Before compiling phonon, you must compile the necessary dependent p...[Details]

Shortages and supply constraints are nothing new to the electronics supply chain, but for automotive leaders, a combination of events since 2020, product planning challenges, multi-layered supply cha...[Details]

A motor control circuit is shown in Figure 1. The normally open button is used to start the motor and the normally closed button is used to stop the motor. In Figure 1, KM is a relay that controls ...[Details]

1. Introduction The most common method for measuring the noise of machinery and equipment is to measure the sound pressure level with a sound level meter. However, in many occasions, this method that...[Details]

A robotic fabric that can shrink, increase in size and move precisely has been created, according to a new study published in Nature Communications by scientists at the University of Sheffield,...[Details]

According to the International Energy Network, the 9th China (Wuxi) International New Energy Conference and Exhibition (CREC2017) opened in Wuxi on November 2. Zhao Wei, senior vice president of Su...[Details]

The active clamp topology is one of the most popular topologies because it allows efficient conversion of bus voltage to the voltage required by logic ICs in an electronic subsystem. An article rev...[Details]

As the global demand for electric vehicles (EVs) continues to grow, drivers are increasingly demanding vehicle performance. They expect longer driving range and faster charging speeds, which are cl...[Details]