3.0SMCJ SERIES
SURFACE MOUNT TRANSIENT VOL
TAGE SUPPRESSOR PEAK PULSE POWER 3000Watts
STAND-OFF VOL
TAGE
5 to 220 Volt
Recongnized File # E210467
FEATURES
0.128(3.25)
0.245(6.22)
0.220(5.59)
0.280(7.11)
0.260(6.60)
0.012(0.305)
0.006(0.152)
0.103(2.62)
0.079(2.00)
0.050(1.27)
0.030(0.76)
0.320(8.13)
0.305(7.75)
0.008(0.203)
0.002(0.051)
• Glass passivated junction
• Low inductance
• Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
• High temperature soldering : 260°C /10 seconds at terminals
• Lead free in compliance with EU RoHS 2011/65/EU directive
• Green molding compound as per IEC61249 Std. . (Halogen Free)
MECHANICAL DATA
•
•
•
•
•
Case: JEDEC DO-214AB,Molded plastic over passivated junction.
Terminals: Solder plated,solderable per MIL-STD-750, Method 2026
Polarity: Color band denotes cathode end
Standard Packaging: 16mm tape (EIA-481)
Weight: 0.008 ounce, 0.23 gram
DEVICES FOR BIPOLARAPPLICATIONS
For Bidirectional use C or CA Suffix for types 3.0SMCJ5.0 thru types 3.0SMCJ220.
Electrical characteristics apply in both directions.
MAXIMUM RA
TINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
Rating
Peak Pulse Power Dissipation on 10/1000μs waveform (Notes 1,2, Fig.1)
Peak Forward Surge Current 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method) (Notes 2,3)
Peak Pulse Current on 10/1000μs waveform (Notes 1) Fig.3
Typical Thermal Resistance Junction to Air
Operating Junction and Storage Temperature Range
Symbol
P
PP
I
FSM
I
PPM
R
θJA
T
J
,T
STG
Value
3000
200
see Table 1
25
-55 to +150
Units
Watts
Amps
Amps
O
0.108(2.75)
• For surface mounted applications in order to optimize board space
C/W
O
C
2.Mounted on 8mm
2
( .013mm thick) land areas.
3.Measured on 8.3ms , single half sine-wave or equivalent square wave , duty cycle= 4 pulses per minute s maximum.
4.A transient suppressor is selected according to the working peak reverse voltage (V
RWM
), which should be equal to or greater than the DC
or continuous peak operating voltage level.
NOTES:
1.Non-repetitive current pulse, per Fig. 3 and derated above T
A
=25°C
per Fig. 2.
November 2,2012-REV.10
PAGE . 1
View All
DIY/Open Source Hardware
京公网安备 11010802033920号
EEWORLD
