Double tube emergency fluorescent light circuit 4
Source: InternetPublisher:桂花蒸 Keywords: Fluorescent lamp BSP contact Updated: 2020/03/31
Rechargeable emergency fluorescent light circuit for Hitachi. It uses
a switch circuit composed of a multi -contact transfer switch SA and two transistors VT3 and VT4 to complete the working mode selection.
The four working modes (there is no 220V mains power at this time. VTi and VT3 are both cut off) are as follows. ① When SA is set to 1, 6V voltage is added to the oscillation circuit through contacts 1 and 4, windings
W3 and W2 , and the fluorescent lamps Gi and Gz light up.
②When SA is set to 2, contacts Z and 4 are connected, VT4 is conducted, and the light EL is on.
③When SA is set to 4, Gi, G2 and EL will not light up.
④When SA is set to 6, Gi, Gz and EL will all light up.
- A white light LED power outage emergency light
- Low cost LED automatic emergency light circuit
- Blinking LED circuit diagram based on LDR and resistor
- Lighting lamp voltage stabilizing circuit (2)
- Gas flameout alarm circuit
- Lighting sound-activated switch circuit using thyristors Part 3
- Desk lamp dimming soft switch circuit
- One of the circuits that control one light in multiple placesb
- WT8089 holiday lights ASIC
- Fluorescent lamp dimming circuit composed of thyristors
- Pulse therapy circuit
- Inpatient pager circuit
- Electronic anti-asthma circuit
- Rural vegetable greenhouse lighting circuit
- Farmland drainage automatic control circuit
- DC ammeter
- Domestic KD8041 integrated phase locked loop
- Varactor Diode Frequency Modulator
- Series crystal oscillator
- Voltage controlled power supply second-order high-pass filter circuit