Three-phase electric energy meter wiring circuit b
Source: InternetPublisher:柯南道尔 Keywords: Three-phase energy meter wiring coil Updated: 2021/02/21
Three-phase circuit active energy meters are used in three-phase three-wire circuits and three-phase four-wire circuits. According to different load requirements, they can be
measured by one meter method, two meter method, or three meter method. Each electric energy meter is composed of a voltage coil and a current coil. The voltage coil and current coil of the first group of components
are connected to U respectively. , and ammeter; the voltage coil and current coil of the second group of components are connected to Uwy and the second ammeter respectively. When wiring
, if
any terminal is connected incorrectly, the aluminum plate will rotate reversely, or even though it rotates forward, the reading will not be equal to the power consumed by the three-phase circuit
. This should be paid special
attention to.
- Simple and practical EPROM detection circuit
- Balcony intelligent invisible anti-theft net
- Detection of Bidirectional Trigger Diode
- Simple and practical motor short circuit tester
- Infrared detector
- TC02 temperature measurement circuit
- A low-cost inductance meter consisting of a single IC
- Electric vehicle luminous voltmeter with undervoltage alarm
- An electronic load meter using LM324 operational amplifier as the main control device
- High-speed gain programmable amplifier circuit
- Temporary power lines
- Lightning protection wiring of oil switch on pole a
- Lightning protection wiring for direct-match generators of 300kW and below b
- Wiring e when leakage protector supplies power to single-phase load in TN system
- Wiring c when the leakage protector supplies power to single-phase loads in the TN system
- Wiring d when leakage protector in TN system supplies three-phase balanced load
- Wiring a when the leakage protector in the TT system is used for single-phase load
- Typical circuit of three-terminal fixed stabilizer a
- Three-phase power meter wiring c
- DX1 type three-phase two-element reactive energy meter Y-shaped connection