M16 Experimental Board
Source: InternetPublisher:jikai233 Updated: 2011/05/05
Including ISP, JTAG, 3310 LCD, discrete RS232 serial port. When PC2-5 does not use JTAG but is used as an IO port, in order to prevent interference from the JTAG pull-up resistor, four jumper pins are designed to switch this situation. Others, such as keyboards, LEDs, etc., are soldered on the blank experimental board by yourself.
Printed circuit board diagram (using Protel dxp 2004 for automatic wiring. The board is made by thermal transfer method. The picture below shows the circuit board that has not been sanded off the thermal transfer layer after being corroded by ferric chloride):
Related downloads:
es_m16_test_board_by_armok_protel_sch_pcb.rar
Printed circuit board diagram (using Protel dxp 2004 for automatic wiring. The board is made by thermal transfer method. The picture below shows the circuit board that has not been sanded off the thermal transfer layer after being corroded by ferric chloride):
Related downloads:
es_m16_test_board_by_armok_protel_sch_pcb.rar Latest Microcontroller Circuits
- Introduction to the use of UnoArduSim
- Temperature and clock display
- Improved circuit diagram of 8050 transistor emitter drive relay
- Using 89C2051 to make a four-way digital display water level controller circuit
- FPGA and DAC0832 interface circuit
- How to make a numeric keyboard using XIAO RP2040
- How to use ESP32 to implement the design of air quality monitoring system
- Make a capacitive soil moisture sensor using ESP32
- Cable test circuit
- MAX232 connection method
京公网安备 11010802033920号