Making a flashing light controller using LM567
Source: InternetPublisher:newrudeman Keywords: controller flashing light LM567 electric light Updated: 2021/08/28
Cl, VDI, VD2, and C2 form a simple capacitor step-down rectifier and voltage stabilizing circuit + output about 8v DC voltage to power the LM567
. Resistors R3, RP and capacitor C3 connected to the 5th and 6th pins of the integrated block form an
ultra-low frequency oscillator with a frequency of II/(R3 + RP) C3. This oscillation signal is directly output from pin 5 and added to the output via R2. The gate of the silicon-controlled VS
turns the VS gap on and off, so the lamp H can flash and emit light. By adjusting the resistance of the potentiometer RP, the flashing frequency of the lamp H can be adjusted
.
- Audio level LED and digital dual display circuit
- IRS2530D electronic ballast circuit diagram
- A light fence circuit diagram with LDR
- LED Flasher circuit using 2 transistors for LED switching
- Design and production of digital number answering machine
- Corridor automatic light-off device
- Three-way music lantern circuit
- Electronic rapid starter for fluorescent lamps
- Small current anti-theft alarm circuit
- Touch lighting switch circuit three
- How to ensure that the power supply works for a long time—PA power analyzer
- Two automatic light circuits for TVs
- Touch delay light switch circuit (6)
- Double button light switch circuit (7)
- Loop timing circuit
- Wire-controlled music lights and stepless dimming dual-purpose controller
- Three-way flashing light controller
- CJM03 composed of fuse scrap emergency controller
- Charging circuit diagram using LM3914 as controller
- stair lighting controller
京公网安备 11010802033920号