MTD2003F stepper motor control circuit
Source: InternetPublisher:宋元浩 Keywords: Stepper motor motor control circuit TD200 Updated: 2021/05/07
M TD200 3F two-phase stepper motor driver This circuit uses dual power supplies: stepper
motor driver and power supply v. . (Recommended maximum 27V) and control logic part use power supply
ycc (sv ±5"). It consists of power stage double H-bridge, base drive circuit, current control
PWM circuit, and overheating protection circuit. See Figure 5 11. Its basic characteristics As follows:
(】) The input terminals are all TTL/CMOS compatible and can be directly connected to CPU.
(2) The
control are shown in Tables 5 to 11. When input When it is LL or HH, the output is in the off
state to prevent the upper and lower bridge arms from being connected.
- Peripheral circuit of automotive motor controller power supply chip
- How to build a simple tachometer using an infrared reflectance sensor
- How to Build a Gesture-Controlled Elevator Prototype Using Arduino Nano
- How to make a wheeled self-balancing robot using ultrasonic sensors
- A simple door handle touch alarm circuit
- Do-it-yourself trial production of phase failure protection device
- Design and production of no-load automatic power-off device for household power supply
- An experimental model of an infrared radio alarm
- Homemade short circuit alarm device
- Car audio system anti-theft circuit
- Differential amplifier emitter negative feedback gain control circuit
- Multi-channel patrol detection control circuit a
- Simple timing control circuit
- Micro remote control receiving and control circuit
- Digital camera flash control circuit
- Stapler control circuit
- Paper tension control circuit
- Table printing machine control circuit
- Photoelectric output control circuit
- Steam iron temperature detection control circuit